TS3USB30_08 Datasheet, PDF (2/18 Pages) Texas Instruments – HIGH-SPEED USB 2.0 (480-Mbps) 1:2 MULTIPLEXER/DEMULTIPLEXER SWITCH WITH SINGLE ENABLE

TS3USB30
SCDS237D – AUGUST 2007 – REVISED MAY 2008......................................................................................................................................................... www.ti.com
PIN DESCRIPTION
NAME
DESCRIPTION
OE
Bus-switch enable
S
Select input
D+, D–, Dn+, Dn–
Data ports
TRUTH TABLE
S
OE
FUNCTION
X
H
Disconnect
L
L
D = D1
H
L
D = D2
BLOCK DIAGRAM
D1+
D+
D2+
D1–
D–
D2–
S
OE
Control
ABSOLUTE MAXIMUM RATINGS⁽¹⁾
over operating free-air temperature range (unless otherwise noted)
V_CC
Supply voltage range
V_IN
Control input voltage range⁽²⁾⁽³⁾
V_I/O
Switch I/O voltage range^(2)(3)(4)
I_IK
Control input clamp current
I_I/OK
I/O port clamp current
I_I/O
ON-state switch current⁽⁵⁾
Continuous current through V_CC or GND
T_stg
Storage temperature range
Dn+, Dn–
D+, D– when V_CC > 0
D+, D– when V_CC = 0
V_IN < 0
V_I/O < 0
MIN
MAX
–0.5
7
–0.5
7
–0.5 V_CC + 0.3
–0.5 V_CC + 0.3
–0.5
5.25
–50
–50
±64
±100
–65
150
UNIT
V
V
V
mA
mA
mA
mA
°C
(1) Stresses beyond those listed under "absolute maximum ratings" may cause permanent damage to the device. These are stress ratings
only, and functional operation of the device at these or any other conditions beyond those indicated under "recommended operating
conditions" is not implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.
(2) All voltages are with respect to ground, unless otherwise specified.
(3) The input and output voltage ratings may be exceeded if the input and output clamp-current ratings are observed.
(4) V_I and V_O are used to denote specific conditions for V_I/O.
(5) I_I and I_O are used to denote specific conditions for I_I/O.
2
Submit Documentation Feedback
Product Folder Link(s): TS3USB30
Copyright © 2007–2008, Texas Instruments Incorporated