TS12A4514_15 Datasheet, PDF (2/18 Pages) Texas Instruments – SPST CMOS ANALOG SWITCHES

TS12A4514, TS12A4515
SCDS193D – AUGUST 2006 – REVISED MARCH 2009 ................................................................................................................................................... www.ti.com
PIN CONFIGURATIONS
TS12A4514
D OR P PACKAGE
(TOP VIEW)
TS12A4515
D OR P PACKAGE
(TOP VIEW)
TS12A4514
SOT-23 PACKAGE
(TOP VIEW)
TS12A4515
SOT-23 PACKAGE
(TOP VIEW)
COM 1
N.C. 2
N.C. 3
V₊ 4
8 NO
7 GND
6 IN
5 N.C.
COM 1
N.C. 2
N.C. 3
V₊ 4
8 NC
7 GND
6 IN
5 N.C.
COM 1
NO 2
GND 3
5 V₊
COM ¹
NC 2
4 IN GND 3
5 ^V₊
4 IN
INPUT
LOW
HIGH
SWITCH STATE
TS12A4514 TS12A4515
OFF
ON
ON
OFF
N.C. – Not internally connected
NO – Normally open
NC – Normally closed
MARKNG INFORMATION (SOTs onl y)
XX XX ^{LOT SPECIFIC CODE}
AE = TS12A4514
AF = TS12A4515
Absolute Minimum and Maximum Ratings⁽¹⁾⁽²⁾
voltages referenced to GND
V₊
V_NC
V_NO
V_COM
T_A
T_stg
Supply voltage range⁽³⁾
Analog voltage range⁽⁴⁾
Continuous current into any terminal
Peak current, NO or COM (pulsed at 1 ms, 10% duty cycle)
ESD per method 3015.7
8-pin plastic DIP (derate 9.09 mW/°C above 70°C)
Continuous power dissipation (T_A = 70°C)
8-pin SOIC (derate 5.88 mW/°C above 70°C)
5-pin SOT-23 (derate 7.1 mW/°C above 70°C)
Operating temperature range
Storage temperature range
Lead temperature (soldering, 10 s)
MIN
MAX
–0.3
13
–0.3
V₊ + 0.3
or ±20 mA
±20
±30
>2000
727
471
571
–40
85
–65
150
300
UNIT
V
V
mA
mA
V
mW
°C
°C
°C
(1) Stresses beyond those listed under "absolute maximum ratings" may cause permanent damage to the device. These are stress ratings
only, and functional operation of the device at these or any other conditions beyond those indicated under "recommended operating
conditions" is not implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.
(2) The algebraic convention, whereby the most negative value is a minimum and the most positive value is a maximum
(3) All voltages are with respect to ground, unless otherwise specified.
(4) Voltages exceeding V₊ or GND on any signal terminal are clamped by internal diodes. Limit forward-diode current to maximum current
rating.
2
Submit Documentation Feedback
Copyright © 2006–2009, Texas Instruments Incorporated
Product Folder Link(s): TS12A4514 TS12A4515