SN74AUC1G06 Datasheet, PDF (2/13 Pages) Texas Instruments – SINGLE INVERTER BUFFER/DRIVER WITH OPEN-DRAIN OUTPUT

SN74AUC1G06
SINGLE INVERTER BUFFER/DRIVER
WITH OPEN-DRAIN OUTPUT
SCES372J – SEPTEMBER 2001 – REVISED JUNE 2005
www.ti.com
DESCRIPTION/ORDERING INFORMATION (CONTINUED)
This device is fully specified for partial-power-down applications using I_off. The I_off circuitry disables the outputs,
preventing damaging current backflow through the device when it is powered down.
For more information about AUC Little Logic devices, please refer to the TI application report, Applications of
Texas Instruments AUC Sub-1-V Little Logic Devices, literature number SCEA027.
FUNCTION TABLE
INPUT
A
H
L
OUTPUT
Y
L
H
LOGIC DIAGRAM (POSITIVE LOGIC)
A2
4Y
Absolute Maximum Ratings⁽¹⁾
over operating free-air temperature range (unless otherwise noted)
V_CC
Supply voltage range
V_I
Input voltage range⁽²⁾
V_O
Output voltage range⁽²⁾
I_IK
Input clamp current
I_OK
Output clamp current
I_O
Continuous output current
Continuous current through V_CC or GND
θ_JA
Package thermal impedance⁽³⁾
T_stg
Storage temperature range
V_I < 0
V_O < 0
DBV package
DCK package
YEA/YZA package
YEP/YZP package
MIN
MAX
–0.5
3.6
–0.5
3.6
–0.5 V_CC + 0.5
–50
–50
±20
±100
206
252
154
132
–65
150
UNIT
V
V
V
mA
mA
mA
mA
°C/W
°C
(1) Stresses beyond those listed under "absolute maximum ratings" may cause permanent damage to the device. These are stress ratings
only, and functional operation of the device at these or any other conditions beyond those indicated under "recommended operating
conditions" is not implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.
(2) The input negative-voltage and output voltage ratings may be exceeded if the input and output current ratings are observed.
(3) The package thermal impedance is calculated in accordance with JESD 51-7.
2