TL783_15 Datasheet, PDF (16/27 Pages) Texas Instruments – TL783 High-voltage Adjustable Regulator

TL783
SLVS036N – SEPTEMBER 1981 – REVISED JANUARY 2015
www.ti.com
10 Power Supply Recommendations
A decoupling capacitor is needed on the IN pin of the TL783 if the TL783 is more than 4 inches from its power
supply's filter capacitor. The differential input and output voltage levels are detailed in Recommended Operating
Conditions.
11 Layout
11.1 Layout Guidelines
Input and output traces should be thick enough to handle desired currents, which can reach up to 700 mA on the
output. ADJ pin traces can be smaller because the adjustment current is negligible.
11.2 Layout Example
OUTPUT
R2
Power
C_adj
R1
Figure 25. Layout Example
Ground
12 Device and Documentation Support
12.1 Trademarks
All trademarks are the property of their respective owners.
12.2 Electrostatic Discharge Caution
These devices have limited built-in ESD protection. The leads should be shorted together or the device placed in conductive foam
during storage or handling to prevent electrostatic damage to the MOS gates.
12.3 Glossary
SLYZ022 — TI Glossary.
This glossary lists and explains terms, acronyms, and definitions.
13 Mechanical, Packaging, and Orderable Information
The following pages include mechanical, packaging, and orderable information. This information is the most
current data available for the designated devices. This data is subject to change without notice and revision of
this document. For browser-based versions of this data sheet, refer to the left-hand navigation.
16
Submit Documentation Feedback
Product Folder Links: TL783
Copyright © 1981–2015, Texas Instruments Incorporated