DRV8811_15 Datasheet, PDF (16/32 Pages) Texas Instruments – DRV8811 Stepper Motor Controller IC

DRV8811
SLVS865I – SEPTEMBER 2008 – REVISED JANUARY 2015
www.ti.com
8.4 Device Functional Modes
8.4.1 RESETn, ENABLEn and SLEEPn Operation
The RESETn pin, when driven active low, resets the step table to the home position. It also disables the H-bridge
drivers. The STEP input is ignored while RESETn is active.
The ENABLEn pin is used to control the output drivers. When ENABLEn is low, the output H-bridges are
enabled. When ENABLEn is high, the H-bridges are disabled and the outputs are in a high-impedance state.
Note that when ENABLEn is high, the input pins and control logic, including the indexer (STEP and DIR pins) are
still functional.
The SLEEPn pin is used to put the device into a low power state. If SLEEPn is low, the H-bridges are disabled,
the gate drive charge pump is stopped, and all internal clocks are stopped. In this state all inputs are ignored
until the SLEEPn pin returns high.
16
Submit Documentation Feedback
Product Folder Links: DRV8811
Copyright © 2008–2015, Texas Instruments Incorporated