CC2640_15 Datasheet, PDF (16/51 Pages) Texas Instruments – CC2640 SimpleLink Bluetooth Smart Wireless MCU

CC2640
SWRS176 – FEBRUARY 2015
www.ti.com
5.6 General Characteristics
Measured on Texas Instruments CC2650EM-5XD reference design with T_c=25°C, V_DDS = 3.0 V, unless otherwise noted.
PARAMETER
TEST CONDITIONS
MIN
TYP
MAX UNIT
Wake-up and Timing
Idle -> Active
14
µs
Standby -> Active
151
µs
Shutdown -> Active
1015
µs
Flash Memory
Supported flash erase cycles before
failure
100
k Cycles
Flash page/sector erase current
Flash page/sector erase time⁽¹⁾
Average delta current
12.6
mA
8
ms
Flash page/sector size
4
KB
Flash write current
Flash write time⁽¹⁾
Average delta current, 4 bytes at a time
4 bytes at a time
8.15
mA
8
µs
(1) This number is dependent on Flash aging and will increase over time and erase cycles
5.7 1-Mbps GFSK (Bluetooth Low Energy) – RX
Measured on Texas Instruments CC2650EM-5XD reference design with T_c=25°C, V_DDS = 3.0 V, f_RF = 2440 MHz, unless
otherwise noted.
PARAMETER
TEST CONDITIONS
MIN
TYP
MAX UNIT
Receiver sensitivity
Differential mode. Measured at the CC2650EM-5XD SMA
connector, BER = 10^-3
–97
dBm
Receiver sensitivity
Single-ended mode. Measured on CC2650EM-4XS, at the SMA
connector, BER = 10^-3
–96
dBm
Receiver saturation
Differential mode. Measured at the CC2650EM-5XD SMA
connector, BER = 10^-3
4
dBm
Receiver saturation
Single-ended mode. Measured on CC2650EM-4XS, at the SMA
connector, BER = 10^-3
0
dBm
Co-channel rejection⁽¹⁾
Wanted signal at -67 dBm, modulated interferer in channel,
BER = 10^-3
-6
dB
Selectivity, ±1 MHz⁽¹⁾
Wanted signal at -67 dBm, modulated interferer at ±1 MHz,
BER = 10^-3
7 / 3 ⁽²⁾
dB
Selectivity, ±2 MHz⁽¹⁾
Wanted signal at -67 dBm, modulated interferer at ±2 MHz,
BER = 10^-3
34 / 25⁽²⁾
dB
Selectivity, ±3 MHz⁽¹⁾
Wanted signal at -67 dBm, modulated interferer at ±3 MHz,
BER = 10^-3
38 / 26⁽²⁾
dB
Selectivity, ±4 MHz⁽¹⁾
Wanted signal at -67 dBm, modulated interferer at ±4 MHz,
BER = 10^-3
42 / 29⁽²⁾
dB
Selectivity, ±5 MHz or more⁽¹⁾
Wanted signal at -67 dBm, modulated interferer at ≥ ±5 MHz,
BER = 10^-3
32
dB
Selectivity, Image frequency⁽¹⁾
Wanted signal at -67 dBm, modulated interferer at image
frequency, BER = 10^-3
25
dB
Selectivity, Image frequency ±1 Wanted signal at -67 dBm, modulated interferer at ±1 MHz from
MHz ⁽¹⁾
image frequency, BER = 10^-3
Out-of-band blocking⁽³⁾
30 MHz to 2000 MHz
3 / 26⁽²⁾
–20
dB
dBm
Out-of-band blocking
2003 MHz to 2399 MHz
–5
dBm
Out-of-band blocking
2484 MHz to 2997 MHz
–8
dBm
Out-of-band blocking
3000 MHz to 12.75 GHz
–8
dBm
Intermodulation
Wanted signal at 2402 MHz, -64 dBm. Two interferers at 2405
and 2408 MHz respectively, at the given power level
-34
dBm
(1) Numbers given as I/C dB
(2) X / Y, where X is +N MHz and Y is -N MHz
(3) Excluding one exception at F_wanted / 2, per Bluetooth Specification
16
Specifications
Submit Documentation Feedback
Product Folder Links: CC2640
Copyright © 2015, Texas Instruments Incorporated