TIBPAL22V10C Datasheet, PDF (11/17 Pages) Texas Instruments – HIGH-PERFORMANCE IMPACT E PROGRAMMABLE ARRAY LOGIC CIRCUITS

TIBPAL22V10AM
HIGH-PERFORMANCE IMPACT ™ PROGRAMMABLE ARRAY LOGIC CIRCUITS
SRPS024 – D2943, OCTOBER 1986 – REVISED MARCH 1992
electrical characteristics over recommended operating free-air temperature range
PARAMETER
VIK
VOH
VOL
IOZH
IOZL
II
IIH
IIL
IOS‡
ICC
VCC = 4.5 V,
VCC = 4.5 V,
VCC = 4.5 V,
VCC = 5.5 V,
VCC = 5.5 V,
VCC = 5.5 V,
VCC = 5.5 V,
VCC = 5.5 V,
VCC = 5.5 V,
VCC = 5.5 V,
TEST CONDITIONS
II = – 18 mA
IOH = –2 mA
IOL = 12 mA
VO = 2.7 V
VO = 0.4 V
VI = 5.5 V
VI = 2.7 V
VI = 0.4 V
VO = 0.5 V
VI = GND,
Outputs open
MIN TYP† MAX
– 1.2
2.4 3.5
0.25 0.5
0.1
– 100
1
25
– 0.25
– 30
– 90
120 180
UNIT
V
V
V
mA
µA
mA
µA
mA
mA
mA
switching characteristics over recommended ranges of supply voltage and operating free-air
temperature (unless otherwise noted)
PARAMETER
FROM
(INPUT)
TO
(OUTPUT)
TEST CONDITIONS
MIN TYP† MAX UNIT
fmax¶
With feedback
22
MHz
tpd
I, I/O
I/O
R1 = 390 Ω,
15
30 ns
tpd
I, I/O (reset)
Q
R2 = 750 Ω,
15
35 ns
tpd
CLK
Q
See Figure 4
10
20 ns
ten
I, I/O
I/O, Q
15
30 ns
tdis
I, I/O
I/O, Q
15
30 ns
† _{All typical values are at VCC = 5 V, TA = 25°C.}
‡ _{Not more than one output should be shorted at a time, and the duration of the short circuit should not exceed one second. VO is set at 0.5 V to}
avoid test problems caused by test equipment ground degradation.
) ₎ ^{¶ fmax (with feedback) =} tsu
1
tpd(CLK
to
Q),
fmax
(without
feedback)
=
tw(low)
1
tw(high)
• POST OFFICE BOX 655303 DALLAS, TEXAS 75265
11