PT7681 Datasheet, PDF (11/12 Pages) Texas Instruments – 30-A Programmable ISR With Margin Up/Down Controls

MECHANICAL DATA
ENE (R–MSIP–T27)
0.66 (16,76) MAX.
0.500 (12,70)
MMSI031 – SEPTEMBER 2001
METAL SINGLE-IN-LINE MODULE
Suffix N
1
Note G
0.025 (0,63) TYP.
0.017 (0,43) TYP.
0.100 (2,54) TYP.
3.00 (76,20) MAX.
1.02 (25,90)
MAX.
0.050 (1,27) TYP.
0.050 (1,27) TYP.
0.160 (4,06) TYP.
0.140 (3,55) MIN.
See Note F
0.050 (1,27)
0.110 (2,79)
3.028 (76,91)
2.928 (74,37)
Note E
0.70 (17,78)
1
0.040 (1,01)
ø0.045 (1,14) MIN. 27 Places
Plated through
0.100 (2,54) 26 Places
0.164 (4,16)
ø0.093 (2,36) MIN. 4 Places
Plated through holes.
See Note G.
PC Layout
NOTES: A. All linear dimensions are in inches (mm).
B. This drawing is subject to change without notice.
C. 2 place decimals are 0.030 (0,76mm).
D. 3 place decimals are 0.010 (0,25mm).
E. Recommended mechanical keep out area.
F. Electrical pin length mounted on printed circuit board, from seating plane to pin end.
G. The case may be electrically connected to power ground plane.
0.54 (13,71)
0.350 (8,89)
0.090 (2,28)
2 Places
4203526/A 08/01
• POST OFFICE BOX 655303 DALLAS, TEXAS 75265