BQ24392-Q1_15 Datasheet, PDF (11/22 Pages) Texas Instruments – BQ24392-Q1 Dual SPST USB 2.0 High Speed Switch With USB Battery Charging Specification Revision 1.2 Detection

www.ti.com
BQ24392-Q1
SLIS160B – AUGUST 2014 – REVISED JANUARY 2015
Figure 4 is from the datasheet of a standard male micro-USB connector and shows how the data connections
(red line) are slightly recessed from the power connections (blue line).
Data Lines
VBUS and
Ground
Figure 4. Data Connections Recessed from Power Connections
However, in some cases the charger is inserted very slowly, causing the VBUS and GND to make contact long
before D+ and D–. Due to this effect, there is no guaranteed detection time as the detection time can vary based
on how long it takes the user to insert the charger. If insertion takes longer than 600 ms, the detection algorithm
of the BQ24392-Q1 will timeout and detect the charger as a non-standard charger.
8.2 Typical Application
The BQ24392-Q1 device is used between the micro or mini-USB connector port and USB host to enable and
disable the USB data path and detect chargers that are inserted into the micro or mini-USB connector.
USB
HOST
DM_HOST
DP_HOST
3.3V
VBUS
100 kΩ 10 kΩ
10 kΩ
SYSTEM
&
CHARGER
GOOD_BAT
SW_OPEN
CHG_AL_N
CHG_DET
Diode
0.5V
BQ24392
VBUS
2.2 Ω
2.2 Ω
DM_CON
2.2 Ω
DP_CON
GND
Figure 5. Application Schematic
0.1 µF
1 µF~
10 µF
USB
PORT
Copyright © 2014–2015, Texas Instruments Incorporated
Submit Documentation Feedback
11