LP2985AIM5X-2.0 Datasheet, PDF (10/22 Pages) Texas Instruments – LP2985LV-N Micropower 150 mA Low-Noise Low-Dropout Regulator in SOT-23 and DSBGA packages for Applications with Output Voltages 2.0V

LP2985LV-N
SNOS510P – NOVEMBER 1999 – REVISED APRIL 2013
APPLICATION HINTS
www.ti.com
EXTERNAL CAPACITORS
Like any low-dropout regulator, the LP2985LV-N requires external capacitors for regulator stability. These
capacitors must be correctly selected for good performance.
Input Capacitor
An input capacitor whose capacitance is ≥ 1 µF is required between the LP2985LV-N input and ground (the
amount of capacitance may be increased without limit).
This capacitor must be located a distance of not more than 1 cm from the input pin and returned to a clean
analog ground. Any good quality ceramic, tantalum, or film capacitor may be used at the input.
Important: Tantalum capacitors can suffer catastrophic failure due to surge current when connected to a low-
impedance source of power (like a battery or very large capacitor). If a Tantalum capacitor is used at the input, it
must be ensured by the manufacturer to have a surge current rating sufficient for the application.
There are no requirements for ESR on the input capacitor, but tolerance and temperature coefficient must be
considered when selecting the capacitor to ensure the capacitance will be ≥ 1 µF over the entire operating
temperature range.
Output Capacitor
The LP2985LV-N is designed specifically to work with ceramic output capacitors, utilizing circuitry which allows
the regulator to be stable across the entire range of output current with an output capacitor whose ESR is as low
as 5 mΩ. It may also be possible to use Tantalum or film capacitors at the output, but these are not as attractive
for reasons of size and cost (see CAPACITOR CHARACTERISTICS section).
The output capacitor must meet the requirement for minimum amount of capacitance and also have an ESR
(equivalent series resistance) value which is within the stable range. Curves are provided which show the stable
ESR range as a function of load current (see ESR graphs Figure 35 and Figure 36).
Figure 35. LP2985LV-N 2.2µF Stable ESR Range Figure 36. LP2985LV-N 4.7µF Stable ESR Range
Important: The output capacitor must maintain its ESR within the stable region over the full operating
temperature range of the application to assure stability.
The LP2985LV-N requires a minimum of 2.2 µF on the output (output capacitor size can be increased without
limit).
It is important to remember that capacitor tolerance and variation with temperature must be taken into
consideration when selecting an output capacitor so that the minimum required amount of output capacitance is
provided over the full operating temperature range. It should be noted that ceramic capacitors can exhibit large
changes in capacitance with temperature (see CAPACITOR CHARACTERISTICS section).
The output capacitor must be located not more than 1 cm from the output pin and returned to a clean analog
ground.
10
Submit Documentation Feedback
Product Folder Links: LP2985LV-N
Copyright © 1999–2013, Texas Instruments Incorporated