RFPT400 Datasheet, PDF (2/5 Pages) TEMEX – Low cost SMD Temperature Compensated Crystal Oscillator for indoor wireless

4.0
Line
4.1
4.2
4.3
4.4
4.5
4.6
-----
5.0
Line
5.1
5.2
5.3
5.4
-----
6.0
Line
6.1
6.2
6.3
6.4
6.5
6.6
-----
7.0
Line
7.1
-----
8.0
Line
8.1
8.2
8.3
8.4
8.5
8.6
-----
CONTROL VOLTAGE
Parameter
Control voltage range
Frequency tuning
Port input impedance
Slope
Linearity
Linearity
Test Condition
Customisable on request. Typical:
Positive
In accordance with MIL-PRF-55310
In accordance with MIL-PRF-55310. Typically 0.05%
Value
0.5 to 2.5
±4.5 to 10
100
Unit
V
ppm
kΩ
0.2 max
%
%
OSCILLATOR OUTPUT-CLIPPED SINEWAVE
Parameter
Test Condition
Output waveform
Clipped sinewave, DC coupled
Output voltage level
Output load
resistance
Output load
capacitance
Value
0.8 to 2
10
10
Unit
Vpp
kΩ
pF
PHASE NOISE
Parameter
SSB phase noise
power density at 1Hz
offset
SSB phase noise
power density at
10Hz offset
SSB phase noise
power density at
100Hz offset
SSB phase noise
power density at 1kHz
offset
SSB phase noise
power density at
10kHz offset
SSB phase noise
power density at
100kHz offset
Test Condition
Typical values for a 19.2MHz oscillator at 25°C
Typical values for a 19.2MHz oscillator at 25°C
Typical values for a 19.2MHz oscillator at 25°C
Typical values for a 19.2MHz oscillator at 25°C
Typical values for a 19.2MHz oscillator at 25°C
Typical values for a 19.2MHz oscillator at 25°C
Value
-64
-101
-120
-134
-143
-143
Unit
dBc/Hz
dBc/Hz
dBc/Hz
dBc/Hz
dBc/Hz
dBc/Hz
JITTER
Parameter
Jitter
Test Condition
Frequency offset from carrier 10Hz to 1MHz
Value
1.7 max
Unit
ps
ENVIRONMENTAL
Parameter
Vibration
Shock
Soldering
RoHS
Storage temperature
range
Humidity
Description
IEC 60068-2-6, test Fc. 10-60Hz 1.5 mm displacement, 60-2000Hz at 20gn, 4 hours in each
of three mutually perpendicular axes at 1 octave per minute
IEC 60068-2-27, test Ea.: 1500gn acceleration for 0.5ms duration, half-sine pulse, 3 shocks in
each direction along three mutually perpendicular axes
SMD product suitable for reflow soldering. Peak temperature 260°C. Maximum time above 220
°C, 60s
Parts are fully compliant with the European Union directive 2002/95/EC on the restriction of
the use of certain hazardous substances in electrical and electronic equipment. Note these
RoHS compliant parts are suitable for assembly using both lead-free solders and tin/lead
solders
-55°C to 125°C
85% for 48 hours at 85°C, non-condensing
Page 2