LNO500D1 Datasheet, PDF (2/5 Pages) TEMEX – Low Noise Oscillator

Low Noise Oscillator series
LNO 500 D1
OCSO @ 500 MHz
Specifications
1.0 Environmental conditions
Line Parameter
Test Condition
Typ. Value Guaranteed
Unit
1.1 Operating temperature range
-40 to +70
°C
1.2 Storage temperature range
-40 to +85
°C
1.3 Shock
Half sine 30 g 11 ms
1.4 Random vibration
1.5 G sensitivity
0.02 g²/Hz within [10 to 350Hz]
0.005 g²/Hz within [1 to 2 kHz]
@10Hz vibration frequency, each axis
5.10^-10
< 2.10^-9
/g
1.6 Humidity
93 % RH at 60 °C
1.7 Low pressure & temperature
120 hPa within [-40 to 55 °C]
1.8 Constant acceleration
18 g all directions
2.0 Electrical interface
Line Parameter
2.1 Supply voltage
2.2 Load impedance
2.3 Control Input
2.4 BIT status
Test Condition
Pin 2
Pin 1, 50 all phases
Pin 4
Pin 3
Typ. Value Guaranteed
+12 ± 0.2
-
< 1.3:1
+2 to +10
or 10
TTL logic level
Unit
V
VSWR
V
MHz
3.0 Performances
Line Parameter
3.1 Nominal frequency
Free running mode
3.2 Frequency calibration
3.3 Frequency stability
3.4 Long term stability
Voltage controlled mode
3.5 Tuning voltage
3.6 Frequency tuning
3.7 Slope
Test Condition
Definition
Control Input not connected
Initial calibration @ 25°C
On full temperature range
After 30 days of continuous operation
1^st year
10 years
Control Input with DC voltage
At Control Input
Monotone
Positive slope
Typ. Value Guaranteed
Unit
500
MHz
0.2
< 0.5
ppm
-
< 2
ppm
-
< 1
ppm
-
< 6
ppm
+2 to +10
8
> 6
2
1.5 to 3
V
ppm
ppm/V
LNO 500 D1 - Revision C – March 2014
2/5
www.rakon.com
Rakon reserves the right to modify herein specifications and information when necessary
to provide optimum performance and cost