J114D-26M Datasheet, PDF (3/6 Pages) Teledyne Technologies Incorporated – CENTIGRID ESTABLISHED RELIABILITY RELAYS

SERIES 114
OUTLINE DIMENSIONS
CASE DETAIL
.375 (9.53)
SQ. MAX.
.335 (8.51)
SQ. MAX.
.275 (6.99) MAX.
WIRE LEAD .750 (19.05) MIN.
PIN: .187 (1.75) .010 (.25)
(See Notes 5 and 8)
.017
(.43)
+.002
–.001
(.05)
(.03)
DIA.
TERMINAL LOCATIONS
(Viewed from Terminals; Numbers for Reference Only)
.031 ±.003
(.79 ±.08)
.035 ±.010
(.89 ±.25)
8
7
1
6
2
5
3
4
.100 ±.010
(2.54 ±.25)
TYP 8 PLACES
DIMENSIONS ARE SHOWN IN INCHES (MILLIMETERS)
GENERAL NOTES
1. Relay contacts will exhibit no chatter in excess of 10 μsec or transfer in excess of 1 μsec.
2. “Typical” characteristics are based on available data and are best estimates. No on-going
verification tests are performed.
3. Unless otherwise specified, parameters are initial values.
4. For reference only. Coil resistance not directly measurable at relay terminals due to
internal series diode. 114DD only.
5. Unless otherwise specified, relays will be supplied with either gold-plated or solder-coated
leads.
6. The slash and characters appearing after the slash are not marked on the relay.
7. Screened HI-REL versions available. Contact factory.
8.
SCHEMATIC DIAGRAMS
114
114D
114DD
SCHEMATICS ARE VIEWED
FROM TERMINALS
Established Reliability
Designator
Relay Series
Ground Pin Option
(See Appendix)
Pad Option
(See Appendix)
Teledyne Part Numbering System for T²R^® Established Reliability Relay
ER 114 Z M4 - 26 A / S Q
Q= Solder Coated Leads
G= Gold Plated Leads
(Notes 5 and 6)
S= 0.187" leads
(Note 6)
Screening and Reliability
Level
Coil Voltage
Teledyne Part Numbering System for Military Qualified (JAN) Relays
J 114 Z M4 - 26 P L
Military (JAN)
Designator
Relay Series
Ground Pin Option
(See Appendix)
Pad Option
(See Appendix)
Screening and Reliability
Level
Terminal Variant
P = 0.187"
Coil Voltage
©2006 TELEDYNE RELAYS
SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE
www.teledynerelays.com
114 Page 3
114/0706/Q1