TC1072 Datasheet, PDF (9/12 Pages) TelCom Semiconductor, Inc – 50mA CMOS LDO WITH SHUTDOWN, ERROR OUTPUT AND VREF BYPASS

100mA CMOS LDO WITH SHUTDOWN,
ERROR OUTPUT AND V_REF BYPASS
PRELIMINARY INFORMATION
TC1073
ELECTRICAL CHARACTERISTICS: V_IN = V_OUT + 1V, IL = 0.1µA, CL = 3.3µF, SHDN > V_IH, T_A = 25°C, unless otherwise noted.
Symbol
Parameter
Test Conditions
Min
Typ
Max
Units
ERROR Open Dranin Output
V_MIN
Minimum Operating Voltage
1.0
—
—
V
V_OL
Output Logic Low Voltage
1mA Flows to ERROR
—
—
400
mV
V_TH
ERROR Threshold Voltage
See Figure 2
—
0.95 x V_R
—
V
V_HYS
ERROR Positive Hysteresis
Note 8
—
50
—
mV
NOTES: 1. V_R is the regulator output voltage setting. (V_R = 2.5V, 2.7V, 3.0V, 3.3V, 5.0V).
2. TC V_OUT = (V_{OUTMAX –} V_OUTMIN) x 10⁶
V_OUT x ∆T
3. Regulation is measured at a constant junction temperature using low duty cycle pulse testing. Load regulation is tested over a load
range from 0.1mA to the maximum specified output current. Changes in output voltage due to heating effects are covered by the
thermal regulation specification.
4. Dropout voltage is defined as the input to output differential at which the output voltage drops 2% below its nominal value.
5. Ground pin current is the regulator pass transistor gate current. The total current drawn from the input supply is the sum of the load
current, ground current and supply current (i.e. I_IN = I_SUPPLY + I_GND + I_LOAD).
6. Thermal Regulation is defined as the change in output voltage at a time T after a change in power dissipation is applied, excluding load
or line regulation effects. Specifications are for a current pulse equal to I_LMAX at V_IN = 6V for T = 10msec.
7. The maximum allowable power dissipation is a function of ambient temperature, the maximum allowable junction temperature and the
thermal resistance from junction-to-air (i.e. T_A, T_J, q_JA). Exceeding the maximum allowable power dissipation causes the device to
initiate thermal shutdown. Please see Thermal Considerations section of this data sheet for more details.
8. Hysteresis voltage is referenced by V_R.
9. Boldface type specifications apply for junction temperatures of – 40°C to +125°C.
PIN DESCRIPTION
Pin No.
(SOT-23A-6)
1
2
3
Symbol
V_IN
GND
SHDN
4
ERROR
5
Bypass
6
V_OUT
Description
Unregulated supply input.
Ground terminal.
Shutdown control input. The regulator is fully enabled when a logic high is applied to this input.
The regulator enters shutdown when a logic low is applied to this input. During shutdown, output
voltage falls to zero and supply current is reduced to 0.05 microamp (typical).
Out-of-Regulation Flag. (Open drain output). This output goes low when V_OUT is out-of-tolerance
by approximately – 5%.
Reference bypass input. Connecting a 470pF to this input further reduces output noise.
Regulated voltage output.
TC1073-01 6/5/97
3