408-2281 Datasheet, PDF (9/12 Pages) TE Connectivity Ltd – Crimping Die Assemblies

408-2281
6. MAINTENANCE AND INSPECTION
Each die assembly is inspected before shipment. It is recommended that the die assembly be inspected
immediately upon arrival at your facility to ensure that it conforms to the gage dimensions provided in Figure 7
and that it has not been damaged during shipment.
Keep the dies together as a complete set (assembly). DO NOT mix dies from different die assemblies or the
same die assemblies. Die part numbers for each die assembly are listed in Figure 6.
DANGER
To avoid personal injury, ALWAYS DISCONNECT electrical and air supply to power unit before performing adjustments,
inspections, or repairs.
Nest (Stationary Die)
(1 Per Die Assembly)
Anvil (Moving Die)
(1 Per Die Assembly)
97.0 [3.80]
Ref
Weight: 255 g [9 oz.]
44.50 [1.75] Ref
Item
59877-1
68006
68007
68008
Die Assembly
68008-1
68009
68010
68010-1 68010-2 68011-1
1 312309-9 312309-1 312309-2 312309-3 1-312309-4 312309-4 1-312309-0 312309-5 1-312309-1 312309-7
2 307465-9 307465-1 307465-2 307465-3 1-307465-3 307465-4 307465-5 1-307465-0 307465-5 307465-7
Item
314948-1 314964-1▲
1 314951-1 314965-1
2 307465-9 307465-7
1976441-1
1-312309-2
1-307465-1
Die Assembly
1976442-1 1976443-1 2217855-1
1-312309-3 314951-2 2-312309-7
1-307465-2 1-307465-2 2-307465-8
2280034-1
2-312309-7
2-307465-8
2280035-1
314951-4
2-307465-7
2217781-1
314951-4
2-307465-7
Item
2844065-1 2844065-2
1 2-312309-8 2-312309-8
2 2-307465-9 2-307465-9
▲Low Pressure Crimp Die Set
2844425-1
3-312309-0
2-307465-7
2844430-1
2-312309-9
3-307465-0
Die Assembly
2844430-2
2-312309-9
3-307465-0
Figure 6
Future
6.1. Daily Maintenance
Each operator must be made aware of —and responsible for— the following steps of daily maintenance.
1. Remove dust, dirt, and other contaminants with a clean brush or a soft, lint-free cloth. DO NOT use
objects that could damage the dies.
2. Make certain the dies are protected with a thin coat of any good SAE 20 motor oil. DO NOT OIL
EXCESSIVELY.
3. When the dies are not in use, mate them and store in a clean dry area.
Rev CK
9 of 12