408-2292-3 Datasheet, PDF (6/6 Pages) TE Connectivity Ltd – Terminal Crimping Dies

408-2292-3
Inspection of Crimping Die Closure
Detail B
Detail A
Gage
Dim•
Dies Positioned at
“Gage Dimension”
“GO” gage must pass
completely through
the die closure
“NO-GO” gage may
enter partially, but must
not pass completely
through the die closure
•42.27 mm [1.664 in.] for Dies Used in Tool No. 69009 and 1752868-1
74.30 mm [2.925 in.] for Dies Used in Tool No. 69082 and 1752786-1
Figure 8
5. If the die closure meets the GO/NO-GO gage
conditions, the die closure is considered
dimensionally correct. If the die closure does not
conform with the GO/NO-GO gage conditions,
contact your local TE Representative.
4.4. Replacement Parts
The crimping dies are not repairable. It may be
advantageous to stock replacement dies to prevent
loss of production time. Figure 9 lists replacement dies
that can be purchased from TE.
Order additional crimping dies through your local TE
Representative, or call 1-800-526-5142, or send a
facsimile of your purchase order to 717-986-7605, or
write to:
CUSTOMER SERVICE (038-035)
TYCO ELECTRONICS CORPORATION
PO BOX 3608
HARRISBURG PA 17105-3608
5. REVISION SUMMARY
• Updated document to corporate requirements
• Added 777 MCM nomenclature to Section 1,
NOTE in Paragraph 2.1.6, 2.3.D, Figures 2, 4, 5,
and 9
• Added new dies to tables in Figures 1, 2, 7, and 9
• Added new NOTE to Paragraph 2.3.D.5
1/0 Thru 400 MCM Dies
500 Thru 777 MCM Dies
ITEM
NO.
1
2
DESC
Moving
Die
Stationary
Die
68200-1
311565-1
1-307719-5
68201-1
311565-2
1-307719-6
DIE SET NUMBER AND COMPONENT PART NUMBERS
68203-1 68204-1 68206-1 68332-1 46757-3
311565-3 311565-4 311565-6 311565-5 1-45835-1
1-307719-8 2-45830-0 45834-8
Figure 9
2-45830-2 305687-9
46758-2
1-305687-0
1-305688-0
46758-3
5-305687-7
1-305688-0
Rev B
6 of 6