408-4352 Datasheet, PDF (5/6 Pages) TE Connectivity Ltd – PRO-CRIMPER III Hand Crimping

Screwdriver
Lockscrew
Ratchet Adjustment
Wheel
Figure 5
5. Make a sample crimp and measure the crimp height. If the dimension is acceptable, replace and
secure the lockscrew. If the dimension is unacceptable, continue to adjust the ratchet, and again
measure a sample crimp.
8. MAINTENANCE
Ensure that the tool and dies are clean by wiping them with a clean, soft cloth. Remove any debris with a clean,
soft brush. Do not use objects that could damage the tool. When not in use, keep handles closed to prevent
objects from becoming lodged in the crimping dies, and store in a clean, dry area.
9. VISUAL INSPECTION
The crimping dies should be inspected on a regular basis to ensure that they have not become worn or
damaged. Inspect the crimp sections for flattened, chipped, worn, or broken areas. If damage or abnormal wear
is evident, the tool must be replaced. See Section 10, REPLACEMENT AND REPAIR.
10. REPLACMENT AND REPAIR
If the dies are damaged or worn excessively, they must be replaced. For customer repair service or to order
replacement parts, call 1-800-522-6752, or fax your purchase order to 717-986-7605, or write to:
Customer Service (038-035)
Tyco Electronics Corporation,
PO Box 3608, Harrisburg, PA 17105-3608.
11. REVISION SUMMARY
Revisions to this instruction sheet include:
 Updated document to corporate requirements
 Changed locator assembly part number in table in Figure 1
5 of 6