408-4352 Datasheet, PDF (1/6 Pages) TE Connectivity Ltd – PRO-CRIMPER III Hand Crimping

PRO-CRIMPER* III Hand Crimping
Tool Assembly 58637-1 with
Die Assembly 58637-2
Instruction Sheet
408-4352
10 DEC 15 Rev B
PROPER USE GUIDELINES
Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. Hand tools are intended for occasional use and low
volume applications. A wide selection of powered application equipment for extended-use, production operations is available.
Locator Assembly
(Supplied with Die
Assembly)
Front of Tool
(Locator Side)
Die Assembly
Moving Jaw
Stationary Jaw
Pivot Pin
Back of Tool Frame
(Wire Side)
PRO-CRIMPER III Hand Tool
Frame 354940-1 (408-9930)
Die Retaining Screw
(2 Places)
Ratchet
Ratchet Adjustment
Wheel
Stationary Handle
primarily for field installation, repair, maintenance work, or prototyping in
industrial, commercial, or institutional applications. Product crimped with this tool will meet
the crimp height requirement for hand tools in the appropriate Application Specification
(114-series), but may not comply with other feature parameters of the specification. TE
Connectivity offers a variety of tools to satisfy your performance requirements. For
additional information, contact PRODUCT INFORMATION at 1-800-522-6752.
Moving Handle
DIE ASSEMBLY
PART NUMBER
LOCATOR
ASSEMBLY†
58637-2
2063771-1
PRODUCT FAMILY‡
Universal
MATE-N-LOK*
Contacts
SIZE (AWG)
20-18
16-14
WIRE SIZE
INSULATION
DIAMETER
1.52-3.30
[.060-.130]
STRIP LENGTH
3.96-4.75
[.156-.187]
† Supplied with die assembly. Also available separately. ‡ Call the PRODUCT INFORMATION number at the bottom of this page for contact part numbers.
Figure 1
1. INTRODUCTION
PRO-CRIMPER III Hand Crimping Tool Assembly 58637-1 consists of Die Assembly 58637-2 and PRO-
CRIMPER III Hand Crimping Tool Frame 354940-1. The die assembly consists of crimping dies and a locator
assembly.
Reasons for revision can be found in Section 11, REVISION SUMMARY.
Read these instructions thoroughly before crimping any contacts.
NOTE
Dimensions on this sheet are in millimeters [with inch equivalents provided in brackets]. Figures and illustrations are for
identification only and are not drawn to scale.
2. DESCRIPTION
The tool features a tool frame with a stationary jaw and handle, a moving jaw, a moving handle, and an
adjustable ratchet that ensures full contact crimping. The tool frame holds a die assembly with two crimping
sections.
© 2015 TE Connectivity family of companies
All Rights Reserved
*Trademark
PRODUCT INFORMATION 1-800-522-6752
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.te.com.
TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product, and/or company names may be trademarks of their respective owners.
1 of 6