408-4345 Datasheet, PDF (5/5 Pages) TE Connectivity Ltd – PRO-CRIMPER III Hand Crimping

408-4345
2. With a screwdriver, adjust the ratchet wheel from the locator side of the tool.
3. Observe the ratchet adjustment wheel. If a tighter crimp is required, rotate the adjustment wheel
counterclockwise to a higher-numbered setting. If a looser crimp is required, rotate the adjustment
wheel clockwise to a lower-numbered setting.
4. Re-assemble the lockscrew.
5. Make a sample crimp and measure the crimp height. If the dimension is acceptable, replace and
secure the lockscrew. If the dimension is unacceptable, continue to adjust the ratchet, and again
measure a sample crimp.
Screwdriver
Ratchet
Adjustment
Wheel
Lockscrew (Typ)
Figure 5
8. MAINTENANCE
Ensure that the tool and dies are clean by wiping them with a clean, soft cloth. Remove any debris with a clean,
soft brush. Do not use objects that could damage the tool. When not in use, keep handles closed to prevent
objects from becoming lodged in the crimping dies, and store in a clean, dry area.
9. VISUAL INSPECTION
The crimping dies should be inspected on a regular basis to ensure that they have not become worn or
damaged. Inspect the crimp sections for flattened, chipped, worn, or broken areas. If damage or abnormal wear
is evident, the tool must be replaced. See Section 10, REPLACEMENT.
10. REPLACEMENT AND REPAIR
Customer-replaceable parts are listed in Figure 1. Parts other than those listed should be replaced by TE to
ensure quality and reliability. For customer repair service or to order replacement parts, call 1-800-522-6752, or
fax your purchase order to 717-986-7605, or write to: Customer Service (038-035), Tyco Electronics
Corporation, PO Box 3608, Harrisburg, PA 17105-3608.
11. REVISION SUMMARY
 Updated document to corporate requirements
 Added new information to table in Figure 1
 Deleted table from Figure 4
Rev B
5 of 5