408-2648 Datasheet, PDF (5/6 Pages) TE Connectivity Ltd – The care, amount of use, and handling of the dies.

408-2648
If you find that the crimp die closures do not
conform with the GO NO-GO gage conditions,
contact your local TE Representative.
4.4. Replacement Parts
Customer-replaceable parts are listed in Figure 7. A
complete inventory should be stocked and controlled
to prevent lost time when replacement of parts is
necessary. Order replacement parts through your TE
Representative, or call 1-800-526-5142, or send a
facsimile of your purchase order to 717-986-7605, or
write to:
CUSTOMER SERVICE (038-035)
TYCO ELECTRONICS CORPORATION
PO BOX 3608
HARRISBURG PA 17105-3608
5. REVISION SUMMARY
This paragraph is reserved for a revision summary of
changes and additions made to this document. The
following changes were made for this revision:
• Updated document to corporate requirements
• Deleted product trademark name in all instances
“A” - Inspection of Wire Barrel Crimp Dies
“B” - Inspection of Insulation Crimp Dies
Insulation
Crimping Dies
1.181 [.0465]
Gage Dim
Wire Barrel Dies are
Bottomed but Not
Under Pressure
“GO” Gage Must Pass
Completely Through
the Die Closure
“NO-GO” Gage May Enter
Partially, but Must Not
Pass Completely Through
the Die Closure
Wire Barrel
Crimp Dies
Figure 6
Rev C
5 of 6