408-2648 Datasheet, PDF (2/6 Pages) TE Connectivity Ltd – The care, amount of use, and handling of the dies.

Terminals
B
B
CB
SOLISTRAND and
STRATO-THERM w/o
Insulation Support
B
Butt Splices
408-2648
SOLISTRAND
Flag Terminal
CB
“B” Equals Wire Barrel
“C” Equals Insulation Barrel
STRATO-THERM
w/Insulation Support
PRODUCT
DESCRIPTION
WIRE
SIZE
RANGE
(AWG)
22-16
SOLISTRAND Terminals and Splices•
16-14
12-10
Uninsulated STRATO-THERM Terminals and
Splices• (Insulation Support)
22-16
16-14
12-10
Uninsulated STRATO-THERM Terminals and
Splices• (Non-Insulation Support)
22-16
16-14
12-10
•Crimped by foot switch control only in machine 69875.
DIE MACHINE
NO.
NO.
68240-1
68241-1
68242-1
69930
69931
69932
69954
69955
69956
69875,
354500-1,
565435-5
69875
Figure 1
WIRE STRIP LENGTH
(Add 1.59 mm [.062 in.] to strip length when
using probe in 69875 machine)
TERMINALS
SPLICES
Min
Max
Min
Max
4.37 [.172]
6.35 [.250]
5.16 [.203]
7.14 [.281]
6.35 [.250]
7.14 [.281]
5.16 [.203] 5.94 [.234] 5.16 [.203] 5.94 [.234]
8.74 [.344] 9.52 [.375] 8.74 [.344] 9.52 [.375]
4.37 [.172]
6.35 [.250]
5.16 [.203]
7.14 [.281]
6.35 [.250]
7.14 [.281]
4.3. Die Closure Inspection
Every die set is inspected for proper die closure
dimensions before packaging. An inspection should
be performed periodically to inspect the die closure for
excessive wear.
Die closure inspection is accomplished using GO
NO-GO plug gages. TE Connectivity neither
manufactures nor sells plug gages. A suggested plug
gage design and the GO NO-GO dimensions of the
plug gage elements are listed in Figures 4 and 5. The
following procedure is recommended for inspecting
the die closure.
Rev C
2 of 6