408-9252 Datasheet, PDF (4/5 Pages) TE Connectivity Ltd – PRO-CRIMPER III Hand Crimping

408-9252
5. Make a sample crimp. If the crimp height is acceptable, the adjustment setting is correct. If the crimp
height is unacceptable, continue to adjust the ratchet, and again measure a sample crimp.
Screwdriver
Ratchet
Adjustment Wheel
Lockscrew
Figure 5
8. MAINTENANCE AND INSPECTION
8.1. Maintenance
Ensure that the tool frame and dies are clean by wiping them with a clean, soft cloth. Remove any debris with a
clean, soft brush. Do not use objects that could damage any components. When not in use, keep tool handles
closed to prevent objects from becoming lodged in the dies, and store in a clean, dry area.
8.2. Visual Inspection
Inspection of the dies should be made on a regular basis to ensure that they have not become worn or
damaged. Inspect the crimping chambers for flattened, chipped, worn, or broken areas. If damage or abnormal
wear is evident, the dies must be replaced. Refer to Section 8, REPLACEMENT.
9. REPLACEMENT AND REPAIR
Customer-replaceable parts are listed in Figure 1. Available separately, Repair Kit 679221-1 includes a
replacement lock nut and a variety of pins, rings, screws, and springs. If the dies are damaged or worn
excessively, they must be replaced. Parts other than those listed should be replaced by TE Connectivity to
ensure quality and reliability. For customer repair service or to order replacement parts, call 1-800-522-6752, or
fax your purchase order to 717-986-7605, or write to: Customer Service (038-035), Tyco Electronics
Corporation, PO Box 3608, Harrisburg, PA 17105-3608.
10. REVISION SUMMARY
 Updated document to corporate requirements
 Updated tooling information on last page of document
Rev M
4 of 5