408-9252 Datasheet, PDF (1/5 Pages) TE Connectivity Ltd – PRO-CRIMPER III Hand Crimping

PRO-CRIMPER III Hand Crimping
Tool Assembly 58433-3 with Die
Assembly 58423-1
Instruction Sheet
408-9252
21 AUG 15 Rev M
PROPER USE GUIDELINES
Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. Hand tools are intended for occasional use and low
volume applications. A wide selection of powered application equipment for extended-use, production operations is available.
Stationary
Jaw
Pivot Pin
Die
Assembly
Moving Jaw
Back of Tool
(Wire Side)
PRO-CRIMPER III Hand
Crimping Tool Frame
354940-1 (408-9930)
Ratchet Adjustment Wheel
The PRO-CRIMPER III Hand Crimping Tool is a “Commercial" grade tool
and is designed primarily for field installation, repair, maintenance work, or
prototyping in industrial, commercial, or institutional applications. Product
crimped with this tool will meet the crimp height requirement for hand tools
in the appropriate Application Specification (114-series), but may not comply
with other feature parameters of the specification. TE Connectivity offers a
variety of tools to satisfy your performance requirements. For additional
information, contact PRODUCT INFORMATION at 1-800-522-6752.
PRODUCT
FAMILY
INSULATION
COLOR
SIZE
(AWG)
WIRE
MAXIMUM INSULATION
DIAMETER ( mm [in.])
PIDG* Terminal or
PLASTI-GRIP* Terminal
Red
Blue
Yellow
22-16
16-14
12-10
3.56 [.140]
4.32 [.170
6.35 [.250]
PIDG FASTON*
Red
22-18
Terminal
Blue
16-14
3.56 [.140]
4.32 [.170]
NOTE: Refer to Catalogs 82004 and 82042 for terminal selection information.
Figure 1
Stationary
Handle
Moving
Handle
STRIP LENGTH
RANGE (mm [in.])
5.15-5.95 [.203-.234]
5.15-5.95 [.203-.234]
7.94-8.73 [.312-.344]
8.33-9.14 [.328-.360]
8.33-9.14 [.328-.360]
1. INTRODUCTION
PRO-CRIMPER III Hand Crimping Tool Assembly 58433-3 consists of PRO-CRIMPER III Hand Crimping Tool
Frame 354940-1 and Die Assembly 58423-1. The tool assembly is used to crimp the terminals listed in
Figure 1. For additional information on the hand tool frame, refer to Instruction Sheet 408-9930. Read these
instructions thoroughly before using the tool assembly.
Reasons for reissue of this instruction sheet are provided in Section 9, REVISION SUMMARY.
NOTE
Dimensions in this instruction sheet are in millimeters [with inches in brackets]. Figures and illustrations are for reference only
and are not drawn to scale.
CAUTION
Terminals crimped with Tool 58433-3 or with Die Assembly 58423-1 are not Listed by Underwriters Laboratories Inc. (UL) or
CSA International.
© 2015 TE Connectivity family of companies
All Rights Reserved
*Trademark
PRODUCT INFORMATION 1-800-522-6752
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.te.com.
TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product, and/or company names may be trademarks of their respective owners.
1 of 5