408-9167 Datasheet, PDF (4/5 Pages) TE Connectivity Ltd – Crimping Die Assembly

408-9167
Suggested Plug Gage Design
GO
NO-GO
Diameter
Diameter
Inspection of Crimping Chamber
Crimping Chamber
W
W
Center Contact
Ferrule Die Closure
Die Closure Configuration Configuration
GO Element
GO element must pass
completely through the
crimping chamber
NO-GO Element
NO-GO element may enter
partially, but must not pass
completely through the
crimping chamber
CONNECTOR
221980-2
221981-2
228596-4
228618-4
CRIMPING CHAMBER
Center Contact
GAGE ELEMENT DIAMETER
GO
NO-GO
“W” WIDTH (MAX)
0.940-0.947 [.0370-.0373] 1.013-1.016 [.0399-.0400]
---
Ferrule
5.359-5.367 [.2110-.2113] 5.484-5.486 [.2159-.2160]
2.54 [.100]
Figure 4
5. REPLACEMENT AND REPAIR
Replacement parts are listed in Figure 5. A complete inventory can be stocked and controlled to prevent lost
time when replacement of parts is necessary. Order replacement parts through your TE Representative, or call
1-800-526-5142, or send a facsimile of your purchase order to 1-717-986-7605, or write to:
CUSTOMER SERVICE (038-035)
TYCO ELECTRONICS CORPORATION
PO BOX 3608
HARRISBURG PA 17105-3608
For repair service, please contact a TE Representative at 1-800-526-5136.
6. REVISION SUMMARY
 Updated document to corporate requirements
 Changed artwork in Figure 4
 Changed information in table in Figure 4.
Rev B
4 of 5