408-9167 Datasheet, PDF (2/5 Pages) TE Connectivity Ltd – Crimping Die Assembly

Pin Connector
Connector Body
408-9167
Cable Strip Lengths
CABLE (RG/U)
142, 142A, 142B
●50-Ohm Connector
Support Sleeve
Socket Connector
Ferrule
10.31 ±0.41
[.406 ±.016]
4.78 ±0.41
[.188 ±.016]
3.58 ±0.41
[.141 ±.016]
PIN
228618-4
221980-2●
CONNECTOR
SOCKET
228596-4
221981-2●
Figure 2
HAND TOOL
69710-1
Center-Contact Crimp
Front of Die
Stationary
Indenter
Braid
Cable
Movable
Indenter
Ferrule
Crimping
Area
Cable
Center Contact
Crimping Area
Ferrule Crimp
Ferrule
Locator
Ferrule Shoulder
Figure 3
4. Insert contact and cable into the dies so that stationary die indenter (crimper) starts entering the
crimping port of the contact. Visually align the other contact port hole over the movable die indenter
(crimper).
NOTE
Squeeze handles slowly until movable die indenter (crimper) enters crimping port.
5. Holding cable in place, actuate tool through a complete cycle.
6. Remove the crimped center contact from the tool.
3.2. Ferrule
1. Slide the ferrule over the two port holes of the contact until ferrule bottoms on connector body.
2. Insert the connector body into the front of the die assembly and into the locator, making sure locator
enters area between shoulder and spring of connector body. See Figure 3.
Rev B
2 of 5