408-7235 Datasheet, PDF (4/4 Pages) TE Connectivity Ltd – CERTI-CRIMP Hand Crimping Tools

408-7235
4. Check the clearance between the bottoming
surfaces of the jaws. If the clearance is 0.025 mm
[.001 in.] or less, the ratchet is satisfactory. If
clearance exceeds 0.025 mm [.001 in.], the ratchet
is out of adjustment and must be repaired. See
Section 6, REPLACEMENT AND REPAIR.
6. REPLACEMENT AND REPAIR
Customer-replaceable parts are listed in Figure 5. A
complete inventory can be stocked and controlled to
prevent lost time when replacement of parts is
necessary. Order replacement parts through your TE
Representative, or call 1-800-526-5142, or send a
facsimile of your purchase order to 717-986-7605, or
write to:
CUSTOMER SERVICE (038-035)
TYCO ELECTRONICS CORPORATION
PO BOX 3608
HARRISBURG PA 17105-3608
For tool evaluation and customer repair service, call
1-800-526-5136.
7. REVISION SUMMARY
• Updated document to corporate requirements
• Changed “Qty Per Tool” amounts in table in
Figure 5
1
2
34
76.2 [3.00] (Closed)
6
5
22.22 [.875]
Weight: 539 g [1 lb 3 oz]
ITEM
PART NUMBER
1
21045-3
2
8-59558-2
3
21045-6
4
2-23620-9
5
39364
6
39207
279.4 [11.00]
REPLACEMENT PARTS
DESCRIPTION
RING, External Crescent Retaining, .188-in. D Shaft
PIN, Retaining, .187-in. D x .521 in. L
RING, External Crescent Retaining, .250-in. D Shaft
PIN, Retaining, .250-in. C x .838 in. L
SPRING, Handle
ADJUSTMENT PIN, Insulation Crimp
Figure 5
QTY PER TOOL
4
2
2
1
1
1
Rev H
4 of 4