408-32084 Datasheet, PDF (4/5 Pages) TE Connectivity Ltd – Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools

408-32084
1. If the crimp height is larger than recommended, remove the ratchet wheel adjustment screw and
rotate the adjustment wheel counterclockwise (+) to a higher setting. Reinstall the screw. Repeat as
required.
2. If the crimp height is smaller than recommended, remove the ratchet wheel adjustment screw and
rotate the adjustment wheel clockwise (-) to a lower setting. Reinstall the screw. Repeat as required.
3. If the crimp cannot be made to conform to the recommended crimp height, the tool or die set must be
replaced. See Section 8, REPLACEMENT.
7. MAINTENANCE AND INSPECTION
7.1. Daily Maintenance
1. Remove dust, moisture, and other contaminants with a clean, soft brush, or a clean, soft, lint-free
cloth. DO NOT use any objects that could damage the dies or tool.
2. Make sure that the proper die retaining screws are properly secured.
3. When the tool is not in use, keep the handles closed to prevent objects from becoming lodged in the
dies. Store the tool in a clean, dry area.
4. Remove all lubrication and accumulated film from the dies by immersing the dies in a suitable
commercial degreaser.
Adjustment
Screw
Ratchet Adjustment
Wheel
7.2. Inspection
Figure 4
Close the tool handles until the ratchet releases, and then allow them to quickly open freely. If they do not open
quickly and fully, the spring is defective. See Section 8, REPLACEMENT.
8. REPLACEMENT
Order replacements through your TE representative, or call 1-800-526-5142, or send a facsimile of your
purchase order to 717-986-7605, or write to:
CUSTOMER SERVICE (038-035)
TYCO ELECTRONICS CORPORATION
PO BOX 3608
HARRISBURG PA 17105-3608
9. REVISION SUMMARY
 Updated document to corporate requirements
 Added part number 2217267-[ ] to document with related information
Rev B
4 of 5