408-2710 Datasheet, PDF (4/5 Pages) TE Connectivity Ltd – AMPOWER Crimping Die Assemblies

Suggested Plug Gage Design
GO Dia.
NO-GO Dia.
408-2710
Dies Positioned At
“Gage Dimension”
Wire Barrel
Crimping Chamber
Gage Dim.
42.27 [1.664]
GO Element
NO-GO Element
CRIMPING
DIE NUMBER
68361-1
68253-1
59867-1
68304-1
GAGE DIMENSION
GO (DIA)
NO-GO (DIA)
7.544 - 7.551
[.2970 - .2973]
7.795 - 7.798
[.3069 - .3070]
8.509 - 8.517
[.3350 - .3353]
8.760 - 8.763
[.3449 - .3450]
9.576 - 9.583
[.3770 - .3773]
9.827 - 9.830
[.3869 - .3870]
10.490 - 10.498
[.4130 - .4133]
10.742 - 10.744
[.4229 - .4230]
Figure 5
5. REPLACEMENT AND REPAIR
Replacement parts are listed in Figure 7. Parts other
than those listed in Figure 7 should be replaced by TE
to ensure quality and reliability of the tool. Order
replacement parts through your TE representative, or
call 1-800-526-5142, or send a facsimile of your
purchase order to 1-717-986-7605, or write to:
CUSTOMER SERVICE (038-035)
TYCO ELECTRONICS CORPORATION
PO BOX 3608
HARRISBURG PA 17105-3608
For additional information regarding the use of a plug
gage, refer to instruction sheet 408-7424.
For customer repair service, contact a TE
representative at 1-800-526-5136.
Figure 6
6. REVISION SUMMARY
Since the last revision of this document, the following
changes were made:
• Updated document to corporate requirements.
Rev G
4 of 5