408-10414 Datasheet, PDF (4/5 Pages) TE Connectivity Ltd – The CERTI--CRIMP II Straight Action Hand Tools are designed to crimp a variety of loose piece terminals

408- 10414
Part Number
3--576692--6
675836--0, --1
Description
Digital Readout
Imperial/Metric
0--1 In/0--25.4mm
675836--0, --1
Mech. Readout
Metric
0--25mm
Manufacturer
Mitutoyo
Corp., Japan
Ref. Number
342--431--30
112--401
Proceed as follows:
1. Select a contact and a wire (maximum size) for
each crimp section listed in the appropriate table at
http://tooling.te.com/data.asp.
2. Refer to the Section 3, and crimp the contact(s).
3. Using a crimp height comparator, measure wire
barrel crimp height as shown in Figure 4. If the
crimp height conforms to that marked on the tool,
the tool is considered dimensionally correct. If not,
return the tool to TE for evaluation and repair (refer
to Section 5).
Position Point
On Center of
Wire Barrel
Opposite Seam
Wire Barrel
Crimp Height
1. Select the maximum size wire and strip it
according to dimensions listed in the drawing
shipped with the tool.
2. Select contact and crimp section corresponding
to the selected wire size (refer to the drawing
shipped with the tool).
3. Position the contact and wire in the crimping
dies, as described in the CRIMPING
PROCEDURE section.
4. Hold the wire in place and squeeze the handles
until the CERTI--CRIMP ratchet control releases.
Hold the handles in this position, maintaining just
enough tension to keep the dies closed.
5. Check the clearance between the bottoming
surfaces of the wire crimper and the wire anvil. See
Figure 1. If the clearance is 0.025 mm [.001 in.] or
less (on at least two of the bottoming surfaces), the
ratchet is satisfactory. If clearance exceeds
0.025 mm [.001 in.], the ratchet is out of
adjustment and must be repaired. See Section 5.
NOTE
i
The insulation crimper does not bottom on the
insulation anvil.
Modified
Anvil
Figure 4
4.5. CERTI- CRIMP Ratchet Control Inspection
The CERTI--CRIMP ratchet control feature on these
hand tools should be checked to ensure that the
ratchet does not release prematurely, allowing the
crimping dies to open before they have fully
bottomed. Obtain a 0.025--mm [.001--in.] shim that is
suitable for checking the clearance between the
bottoming surfaces of the crimping dies. Proceed as
follows:
5. REPLACEMENT AND REPAIR
Replacement parts are listed in Figure 5. Parts other
than those listed in Figure 5 should be replaced by TE
to ensure quality and reliability of the tool. Order
replacement parts through your TE Representative, or
call 1--800--526--5142.
Tools may also be returned for evaluation and repair.
For tool repair service, contact a TE Representative
at: 1--800--526--5136.
6. REVISION SUMMARY
: Updated web address in all instances
4 of 5
Rev C