108-36033 Datasheet, PDF (4/6 Pages) TE Connectivity Ltd – The product described in this document has not been fully tested to ensure conformance to the requirements outlined below

108-36033
Test Description
Barometric pressure, temperature
cycling.
Herm etic seal.
R equirem ent
See Note.
Leakage rate less than 1 X 10^-8 cc
He/sec.
See Note.
Procedure
MIL-STD 202, Method 105C,
Condition C.
MIL-STD 202, Method 112C,
Condition C.
NOTE
Shall meet visual requirements, show no physical damage, and meet requirements of additional
tests as specified in the Product Qualification and Requalification Test Sequence shown in Figure
2.
Figure 1 (end)
3.6. Product Qualification and Requalification Test Sequence
Test or Examination
Initial examination of product
Contact resistance
Insulation resistance
W ithstanding voltage
Vibration
Mechanical shock
Durability
Contact engaging force
Contact separating force
Thermal shock
Humidity, steady state
Temperature life
Barometric pressure, temperature cycling
Hermetic seal
Final examination of product
Test Group (a)
1
2(c)
Test Sequence (b)
1,19
1,18
4,8
5,9
2
3
3,11,15 4,13,17
9
10
10
11
7
8
5,17
6
6,18
7
14
15
12
14
16
13(d)
2,12,16
19
18
NOTE ^{(a) See paragraph 4.1.A.}
(b) Numbers indicate sequence in which tests are performed.
(c) This test group is applicable to hermetic seal type receptacles only.
(d) HiPot is performed at each temperature extreme and reduced barometric pressure,
70000 feet.
Figure 2
Rev O2
4 of 6