108-36033 Datasheet, PDF (1/6 Pages) TE Connectivity Ltd – The product described in this document has not been fully tested to ensure conformance to the requirements outlined below

Design
Objectives
Standard LGH Connectors,
Series 1/2I, 1/2LI, 1I, 1LI, 2I, 3I and 4I
108-36033
Rev O2
DESIGN OBJECTIVES
The product described in this document has not been fully tested to ensure conformance to the requirements outlined below. Therefore
Tyco Electronics makes no representation or warranty, express or implied, that the product will comply with these requirements. Further,
Tyco Electronics may change these requirements based on the results of additional testing and evaluation. Contact Tyco Electronics
Engineering for further details.
1.
SCOPE
1.1. Content
This specification covers performance, tests and quality requirem ents for the Tyco Electronics LGH
standard high voltage 1/2I, 1/2LI, 1I, 1LI, 2I, 3I and 4I series molded end leads and receptacles. These
leads and receptacles are designed for commercial, industrial and military type applications requiring
operation over wide environments.
1.2. Qualification
W hen tests are perform ed on the subject product line, procedures specified in Figure 1 shall be used.
All inspections shall be perform ed using the applicable inspection plan and product drawing.
2.
APPLICABLE DOCUMENTS
The following docum ents form a part of this specification to the extent specified herein. Unless
otherwise specified, the latest edition of the document applies. In the event of conflict between the
requirements of this specification and the product drawing, the product drawing shall take precedence.
In the event of conflict between the requirements of this specification and the referenced documents,
this specification shall take precedence.
2.1. Tyco Electronics Documents
! 109 Series: Test Specifications as indicated in Figure 1
! 109-197: Test Specification (AMP Test Specifications vs EIA and IEC Test Methods)
! 114- : Application Specification
! 501- : Qualification Test Report
2.2. Commercial Standard
EIA-364:
Electrical Connector/Socket Test Procedures Including Environm ental Classifications
2.3. Military Standard
MIL-STD-202: Test Methods For Electronic And Electrical Component Parts
3.
R EQ U IR EM EN T S
3.1. Design and Construction
PRELIMINARY ^{Product shall be of the design, construction and physical dimensions specified on the applicable product}
drawing.
©2011 Tyco Electronics Corporation, | Indicates change
a TE Connectivity Ltd. Company
*Trademark
All Rights Reserved
TE logo is a trademark.
For latest revision, visit our website at www.te.com/documents.
For Regional Customer Service, visit our website at www.te.com
Other products, logos, and company names might be trademarks of their respective owners.
1 of 6
LOC B