1200 Datasheet, PDF (36/39 Pages) Schurter Inc. – Appliance inlet for low voltage, Snap-in Mounting, Front Side, Solder or Quick-connect Terminal

Page 36 of 39
SPECIFICATION 1200, ISSUE 12
Alternatively:
Overlap
=
⎛⎝⎜ _{1 −}
c
d
⎞⎠⎟
x100%
Where:
c = Distance between adjacent visible tape edges measured along the axis of the cable
d = Width of the tape measured along the axis of the cable
5.
5.1
5.1.1
5.1.2
5.2
STANDARD PACKAGING
Unless otherwise specified (see 6.1), the following shall define the standard spooling and
labeling requirements for cable furnished under this specification. Standard shipping tolerance
on ordered quantity shall be ± 10 percent.
SPOOLING REQUIREMENTS
All layers of cable shall be wound on spools or reels (see 5.1.1) with sufficient tension to
prevent shifting of layers and creation of crossovers within layers. Finished cable lengths
shall be wound on spools or reels with all ends exposed. There shall be no more than 5
lengths per spool or reel and no length shall be less than 50 feet (15 m).
Spools and Reels
Spools and reels shall be of a nonreturnable type. Each spool and reel shall have an
appropriate diameter for the respective wire or cable size. In no case shall the barrel of the
spool or reel have a diameter less than 3.5 inches (89 mm). Spools and reels shall be suitably
finished to prevent corrosion under typical storage and handling conditions. Loaded plastic
spools shall not exceed 50 pounds (23 kg). Loaded wooden reels shall have no weight
restriction.
Containers
Unless otherwise specified (see 6.1), finished cable shall be delivered in standard commercial
containers so constructed as to ensure acceptance by common or other carrier for safe
transportation at the lowest rate to the point of delivery.
LABELING REQUIREMENTS
All spools and reels shall be identified with the following information:
Manufacturer's Part Number
Lot Number
Quantity in Feet (or Meters)
Name of Manufacturer
Tyco Electronics Corporation, a TE Connectivity Ltd. Company
© 2011-2012 Tyco Electronics Corporation. All rights reserved.
NOTE: ANY PRINTED COPY OF THIS DOCUMENT
IS AN UNCONTROLLED COPY.