1200 Datasheet, PDF (1/39 Pages) Schurter Inc. – Appliance inlet for low voltage, Snap-in Mounting, Front Side, Solder or Quick-connect Terminal

Raychem Wire and Cable
501 Oakside Avenue, Redwood City, CA 94063-3800
SPECIFICATION:
1200
THIS ISSUE:
Issue 12
DATE:
20 February 2012
REPLACES:
Issue 11
PAGE:
1 of 39
CABLE, HIGH-FREQUENCY AND CONTROLLED ELECTRICAL
1.
SCOPE
This specification covers inspection methods, procedures and requirements for high-frequency
and controlled electrical cables.
2.
2.1
2.1.1
APPLICABLE DOCUMENTS
GOVERNMENT-FURNISHED DOCUMENTS
The following documents, of the issue in effect on the date of invitation for bids or request for
proposal, form a part of this specification to the extent specified herein.
Department of Defense
SPECIFICATIONS
Federal
UU-T-450
Tissue, Facial
Military
MIL-DTL-17
Cables, Radio Frequency, Flexible and Semirigid, General
Specification For
MIL-DTL-915
Cable, Electrical, for Shipboard Use, General Specification For
MIL-DTL-29606
Wire, Electrical, Stranded, Uninsulated Copper, Copper Alloy, or
Aluminum, or Thermocouple Extension, General Specification For
(Copies of Department of Defense documents may be obtained from the Naval Publications
and Forms Center, Standardization Documents Order Desk, Bldg. 4D, 700 Robbins Ave.,
Philadelphia, PA 19111-5094; or at http://assist.daps.dla.mil/quicksearch/.)
Tyco Electronics Corporation, a TE Connectivity Ltd. Company
© 2011-2012 Tyco Electronics Corporation. All rights reserved.
NOTE: ANY PRINTED COPY OF THIS DOCUMENT
IS AN UNCONTROLLED COPY.