408-9872 Datasheet, PDF (3/3 Pages) TE Connectivity Ltd – Reasons for reissue of this instruction sheet are provided in Section 6, REVISION SUMMARY.

408- 9872
Connector Positioned
(Cover Up) in Lower Insert
and Between Locators
Cable Stop
Locators Positioned
Against Connector
5. REPLACEMENT AND REPAIR
Figure 5 lists customer--replaceable parts for the
connector--specific kit. To purchase kits or
replacement parts, contact your local Representative,
or call 1--800--526--5142, or send a facsimile of your
order to 1--717--986--7605, or write to:
CUSTOMER SERVICE (38--35)
TYCO ELECTRONICS CORPORATION
PO BOX 3608
HARRISBURG, PA 17105--3608
1
Cable Guides
Positioned Against Cable
2
Note: Guard Removed for Clarity
Figure 4
5. Slide the cable guide (located on the side of the
cable with the registration mark) against the cable
and secure it with the thumbscrew. Slide the other
cable guide against the cable and secure it with the
thumbscrew. See Figure 4.
6. Slide the cable guide (located on the side of the
cable with the registration mark) against the cable
and secure it with the thumbscrew. Slide the other
cable guide against the cable and secure it with the
thumbscrew. See Figure 4.
DANGER
Before terminating any connectors, re- install the
front guard on the frame assembly. When using
the pneumatic auto- cycle unit, reconnect the air
supply to the main air valve.
7. Perform a test termination and inspect the
connector to ensure that the cable conductors are
properly aligned with the contacts. If available, use
a tester to inspect the termination or remove the
connector cover and inspect the termination with a
microscope. Refer to 408--9875 for termination
procedure and 114--25029 for termination height
dimension.
4
3
ITEM
PART
NUMBER
DESCRIPTION
QTY
PER KIT
1
679100--2 UPPER TOOL
1
2
679074--1 INSERT, Lower
1
3
679075--1 LOCATOR
2
4
679069--3 STOP, Cable
1
—
1--21000--40
SCREW, Socket Head Cap,
4--40¢.380--in. Long
2
Figure 5
6. REVISION SUMMARY
Revisions to this instruction sheet include:
S Updated document to corporate requirements.
Rev E
3 of 3