408-9872 Datasheet, PDF (1/3 Pages) TE Connectivity Ltd – Reasons for reissue of this instruction sheet are provided in Section 6, REVISION SUMMARY.

Connector- Specific Kit 679167- 1 for
AMP- LATCH* System 50 Receptacle Connectors
Instruction Sheet
408- 9872
18 Mar 11 Rev E
Lower Insert
Connector- Specific Kit
Locators
Upper Tool
Cable Stop
Manual Arbor Frame
Assembly 91085- 2 (Ref)
Typical Application
Base Assembly Universal
Arbor Tool 768338- 2
Guard (Ref)
Figure 1
1. INTRODUCTION
This instruction sheet covers the installation and
setup procedures for Connector--Specific Kit
679167--1. The connector--specific kit is used with
Base Assembly Universal Arbor Tool 768338--2
(408--9875) and Manual Arbor Frame Assembly
91085--2 (408--7777) (shown in Figure 1) or
Pneumatic Auto--Cycle Unit 91112--3 (408--6732) to
terminate AMP--LATCH System 50 receptacle
connectors onto cable.
Refer to instruction sheets (given in parenthesis)
supplied with the tool for tooling information. For
information on AMP--LATCH connectors, contact
PRODUCT INFORMATION at the number at the
bottom of this page.
Reasons for reissue of this instruction sheet are
provided in Section 6, REVISION SUMMARY.
NOTE
i
Dimensions in this instruction sheet are in
millimeters [followed by inches in brackets].
2. DESCRIPTION (Figure 1)
The connector--specific kit consists of an upper tool, a
lower insert, two locators, and a cable stop. The
upper tool is secured to the upper tool mount and
applies an even force over the length of the connector
during termination. The locators and the lower insert
properly align the connector for termination.
3. CABLE REQUIREMENT
The receptacle connectors accept 0.64 [.025]
centerline ribbon cable with solid or stranded
conductors size 30 AWG or stranded conductors size
32 AWG (7 strands/40 AWG). Refer to Figure 2 for
recommended cable dimensions.
E2011 Tyco Electronics Corporation, a TE Connectivity Ltd. Company TOOLING ASSISTANCE CENTER 1--800--722--1111
All Rights Reserved
PRODUCT INFORMATION 1--800--522--6752
TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks.
*Trademark. Other logos, product and/or Company names may be trademarks of their respective owners.
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.te.com
1 of 3
LOC B