408-9623 Datasheet, PDF (3/3 Pages) TE Connectivity Ltd – Seating Tool 535072- 1 for Type C

408- 9623
5. MAINTENANCE AND INSPECTION
5.1. Daily Maintenance
It is recommended that each operator be made aware
of, and responsible for, the following steps of daily
maintenance:
1. Remove dust, moisture, and other contaminants
with a clean, soft brush or lint--free cloth. DO NOT
use objects that could damage the rectangular
blades or other tool components.
2. Ensure that the proper screws and rectangular
blades are in place and secured.
3. When the seating tool is not in use, store it in a
clean, dry area.
5.2. Periodic Inspection
The seating tool is assembled and inspected before
shipment. Inspect the seating tool immediately upon
arrival to ensure that it has not been damaged during
shipment.
Thereafter, regular inspections should be performed
by quality control personnel. A record of scheduled
inspections should remain with the seating tool or be
supplied to personnel responsible for the seating tool.
The inspection frequency should be based on the
amount of use, working conditions, operator training
and skill, and established company standards.
6. REPLACEMENT AND REPAIR
The parts for the seating tool shown in Figure 1 are
customer-- replaceable. A complete inventory can be
stocked and controlled to prevent lost time when
replacement of parts is necessary. Order replacement
parts through your Representative, or call
1--800--526--5142, or send a facsimile of your
purchase order to 1--717--986--7605. or write to:
CUSTOMER SERVICE (038--035)
TYCO ELECTRONICS CORPORATION
PO BOX 3608
HARRISBURG PA 17105--3608
For customer repair service, call 1--800--526--5136.
7. REVISION SUMMARY
Revisions to this instruction sheet include:
S Changed company logo
S Updated instruction sheet to corporate
requirements
S Removed obsolete seating tools
S Changed “housing” to “side plates”
S Added pc board support fixture and part
numbers of customer--replaceable parts to
Figure 1
S Added requirements for pc board support
fixture to Paragraph 3.1
S Changed “push pins” to “rectangular blades” in
Section 4 and Paragraph 5.1
S Replaced address for returning tools for
evaluation and repair with customer repair
service phone number
Rev E
3 of 3