408-9140 Datasheet, PDF (3/3 Pages) TE Connectivity Ltd – PRO- CRIMPER* III Hand Crimping

408- 9140
4.3. Ratchet Adjustment
The ratchet mechanism features an adjustment wheel
with eight settings. The adjustment wheel controls the
amount of handle pressure exerted on the tool jaws
and crimping dies during crimping. If the crimp is not
acceptable, adjust the ratchet as follows:
1. Sufficiently loosen the screw at the ratchet
adjustment wheel so that the wheel can be rotated
above the post that engages the teeth in the wheel.
2. If the crimp is too loose, turn the wheel to a
higher notch (for example, if the wheel is set at
notch no. 5, move the wheel to notch no. 6). If the
crimp is too tight, move the wheel to a lower notch.
3. Tighten the screw at the ratchet adjustment
wheel.
NOTE
i
Other dies of the PRO- CRIMPER III Series Hand
Criming Tool may be used in this tool; however,
the ratchet adjustment wheel may require
adjustment to achieve acceptable crimp height.
5. PARTS REPLACEMENT
Customer--replaceable parts are shown in Figure 1.
Available separately, PRO--CRIMPER III Repair Kit
679221--1 includes a variety of pins, rings, screws,
and springs. If the dies are damaged or worn
excessively, they must be replaced. Order the repair
kit and replaceable parts through your TE
Connectivity Representative, or call
1--800--526--5142, or send a facsimile of your
purchase order to 1--717--986--7605, or write to:
Customer Service (38--35)
Tyco Electronics Corporation
P.O. Box 3608
Harrisburg, PA 17105--3608
If the crimp cannot be made to conform to the
dimensions provided in the appropriate product
application specification, the tool and/or dies are
defective and must be replaced.
6. REVISION SUMMARY
S Updated document to corporate requirements
S New logo
1.09 mm
+.08
- .03
.043 in.
+.003
- .001
5.28 mm + .10
[.208 in. + .004]
1.27 mm
+.08
- .05
.050 in.
+.003
- .002
Figure 5
6.10 mm + .10
[.240 in. + .004]
Rev D
3 of 3