408-9140 Datasheet, PDF (1/3 Pages) TE Connectivity Ltd – PRO- CRIMPER* III Hand Crimping

PRO- CRIMPER* III Hand Crimping
Tool Assembly 58433- 1
Instruction Sheet
408- 9140
20 APR 11 Rev D
PROPER USE GUIDELINES
Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. Hand tools are intended for occasional use and low volume
applications. A wide selection of powered application equipment for extended- use, production operations is available.
Die Assembly
58435- 1
(Replaceable Item)
Pivot Pin
PRO- CRIMPER III
Hand Tool Frame
Assembly 354940- 1
(408- 9930)
Crimp Section
Identification
Numbers
Ratchet
Adjustment
Wheel
Screw
Refer to Catalog 82074
For Applicable Connectors
1. INTRODUCTION
Figure 1
3. CRIMPING PROCEDURE (Figure 2)
PRO--CRIMPER III Hand Crimping Tool 58433--1
(Figure 1) is designed to crimp 50--Ohm Commercial
BNC and TNC plugs and jacks onto RG 58/U, RG
59/U, and RG 62/U cable.
Reasons for reissue of this sheet are provided in
Section 6, REVISION SUMMARY.
2. DESCRIPTION (Figure 1)
The tool features a replaceable die assembly
(58435--1) with two ferrule crimp sections and two
center contact crimp sections. The crimp sections are
marked to identify the cable sizes used with the
connectors as follows:
S RG 58/U crimp sections (center contact and
ferrule) are identified by the number “58”
located below the crimp section.
S RG 59/U and 62/U crimp sections (center
contact and ferrule) are identified by the
number “59” located below the crimp section.
3.1. Center Contact
1. Slide the ferrule onto the cable, then strip the
cable according to the dimensions in the
appropriate connector instruction sheet.
2. Slide the center contact onto the center
conductor of the cable; then insert the contact
assembly into the contact crimp section of the dies.
NOTE
i
Make sure that the flange on the end of the
center contact butts against the crimping die. See
Figure 3.
3. Crimp the center contact by holding the contact
and cable in place; then close the tool handles until
the ratchet releases.
4. Remove the crimped center contact.
E2011 Tyco Electronics Corporation, a TE Connectivity Ltd. Company
All Rights Reserved
*Trademark
TOOLING ASSISTANCE CENTER 1--800--722--1111 This controlled document is subject to change.
PRODUCT INFORMATION 1--800--522--6752
For latest revision and Regional Customer Service,
visit our website at www.te.com
TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product and/or Company names may be trademarks of their respective owners.
1 of 3
LOC B