408-8996 Datasheet, PDF (3/3 Pages) TE Connectivity Ltd – Seating Tool Assembly

408-8996
6. Check assembly for proper seating according to
the following:
a. the widest section of each compliant pin is
inside its intended pc board hole
b. each connector alignment post is in its
intended pc board hole
c. the connector assembly is seated on the pc
board with a seating height of 25.22 mm [.993 in.]
measured from the top of the connector assembly
(not including the panel ground springs) to the top
of the pc board
d. if present, the gap between the connector
assembly standoffs and the pc board is no more
than 0.10 mm [.004 in.]
NOTE
i
For detailed application requirements of the
connector assembly, refer to Application
Specification 114-13147.
6. MAINTENANCE AND INSPECTION
The seating tool is assembled and inspected before
shipment. It is recommended that the seating tool be
inspected immediately upon arrival at your facility to
ensure that it has not been damaged during shipment,
and that it conforms to the dimensions provided in
Figure 3.
6.1. Daily Maintenance
It is recommended that each operator be made aware
of, and responsible for, the following steps of daily
maintenance:
1. Remove dust, moisture, and contaminants with a
clean, soft brush or a lint-free cloth. DO NOT use
objects that could damage the components.
2. When the seating tool is not in use, store it in a
clean, dry area.
6.2. Periodic Inspection
Regular inspections should be performed by quality
control personnel. A record of scheduled inspections
should remain with the seating tool or be supplied to
personnel responsible for the seating tool assembly.
Inspection frequency should be based on amount of
use, working conditions, operator training and skill,
and established standards.
7. REPLACEMENT AND REPAIR
Customer-replaceable parts are listed in Figure 3. 
A complete inventory should be stocked and
controlled to prevent lost time when replacement of
parts is necessary. Parts other than those listed should
be replaced by TE Connectivity to ensure quality and
reliability. Order replacement parts through your
representative, or call 1-800-526-5142, or send a
facsimile of your purchase order to 717-986-7605, or
write to:
CUSTOMER SERVICE (038-035)
TYCO ELECTRONICS CORPORATION
PO BOX 3608
HARRISBURG PA 17105-3608
For customer repair service, call 1-800-526-5136.
98.35 mm
[3.872 in.]
35.69 mm
[1.405 in.]
1
4 _{29.72 mm}
[1.17 in.]
35.69 mm
[1.405 in.]
2
3
REPLACEMENT PARTS
ITEM
PART
NUMBER
DESCRIPTION
QTY PER
TOOL
1 1213667-1 BLOCK, Top
1
2 1213669-1 PLATE, Back
1
3 1213668-1 PLATE, Side
2
4
2-21002-1
SCREW, Button Head
Socket Cap, 8-32 X .375 in.
Figure 3
8. REVISION SUMMARY
Since the previous version of this document, the
following changes were made:
• Updated document to corporate requirements.
Rev A
3 of 3