408-8996 Datasheet, PDF (1/3 Pages) TE Connectivity Ltd – Seating Tool Assembly

Seating Tool Assembly 1213670-1
For Stacked RJ-45 Integrated
Connector Assembly
Side Plate
(2 Places)
Back Plate
Alignment Post
Instruction Sheet
408-8996
19 DEC 11 Rev A
Top Block
Cutout
Stacked RJ-45 Integrated
Connector Assembly
Compliant-Pin Contact
Printed Circuit (PC)
Board (Ref)
PC Board Support Fixture
(Ref)
Figure 1
1. INTRODUCTION
Seating Tool Assembly 1213670-1 is used to seat a
stacked RJ-45 integrated connector assembly
(reference part number 1658821-1) having compliant
pin contacts and alignment posts onto the pc board.
Refer to Application Specification 114-13147 for
description of connector assembly.
NOTE
i
All numerical values in this instruction sheet are in
metric units [with U.S. customary units in brackets].
Dimensions are in millimeters [and inches]. Figures
are not drawn to scale.
2. DESCRIPTION
The seating tool consists of a top block, two side
plates, and a back plate. The back plate has a cutout
designed to accept the power-over-ethernet (PoE)
chip set of the connector assembly during seating of
the connector assembly. See Figure 1.
The top block provides a surface to accept the force
applied by the application tool to seat the connector
assembly onto the pc board. During seating, the top
block and side plates protect the connector assembly,
and the back plate supports the back of the connector
assembly.
3. REQUIREMENTS
3.1. PC Board Support Fixture (Customer Supplied)
A pc board support must be used to provide proper
support for the pc board and to protect the pc board
and the connector and connector assembly from
damage. The support fixture must be designed for
specific needs using the following recommendations:
• it should be at least 25.4 mm [1.0 in.] longer and
wider than the pc board
• it should have flat surfaces with holes or a channel
large enough and deep enough to receive any
protruding components of the connector assembly
3.2. Application Tool
Power for seating tools must be provided by an
application tool (with a ram) capable of supplying a
downward force of 44.5 N [10 lb-force] per contact.
©2011 Tyco Electronics Corporation, a TE Connectivity Ltd. Company TOOLING ASSISTANCE CENTER 1-800-722-1111 This controlled document is subject to change.
All Rights Reserved
PRODUCT INFORMATION 1-800-522-6752
For latest revision and Regional Customer Service,
*Trademark
visit our website at www.te.com
TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product and/or Company names may be trademarks of their respective owners.
1 of 3
LOC B