408-8465 Datasheet, PDF (3/3 Pages) TE Connectivity Ltd – Read these instructions and understand them before using the seating tool.

View After Seating
408-8465
Applicator Ram
(Fully Down)
Applicator Shut Height
(Ram Fully Down)
(See Section 4, Step 1)
Seating Height
(Header Seated)
38.10 +0.25/-0.00mm
[1.50 +.010/-.000 In.]
Seating Tool Bottomed
on Housing Floor
Contact Posts in Holes in
PC Board and Aligned with
Holes in Board Support
PC Board
PC Board Support
Fixture (Ref)
Figure 3
5. TOOL INSPECTION
Each seating tool is assembled and inspected before
shipment. We recommend that the tool be inspected
immediately upon arrival at your plant to ensure that it
has not been damaged during shipment.
Regular inspections should be performed by quality
control personnel. A record of scheduled inspections
should remain with the tool or be supplied to
supervisory personnel responsible for the tool. The
inspection frequency should be based on the amount
of use, working conditions, operator training and skill,
and established company standards.
6. MAINTENANCE
It is recommended that each operator be made aware
of, and responsible for, the following steps of daily
maintenance:
1. Remove dust, moisture, and other contaminants
with a clean, soft brush, or lint-free cloth. Do NOT
use objects that could damage the tool.
2. Ensure that the screws are in place and secured.
3. When the tool is not in use, store it in a clean, 
dry area.
7. REPLACEMENT AND REPAIR
The parts listed in Figure 2 are customer-replaceable.
A complete inventory can be stocked and controlled to
prevent lost time when replacement of parts is
necessary. Order replacement parts through your Tyco
representative, or call 1-800-526-5142, or send a
facsimile of your purchase order to 717-986-7605, or
write to:
CUSTOMER SERVICE (038-035)
TYCO ELECTRONICS CORPORATION
PO BOX 3608
HARRISBURG PA 17105-3608
For customer repair service, call 1-800-526-5136.
8. REVISION SUMMARY
Since the previous version of this document, the
following changes were made:
• Changed Paragraph 3.2.
• Updated document to corporate requirements.
Rev A
3 of 3