408-8340 Datasheet, PDF (3/3 Pages) TE Connectivity Ltd – Reasons for reissue of this instruction sheet are provided in Section 8, REVISION SUMMARY.

408-8340
Air Hose
Clamp Solenoid Valve
Figure 4
1. Return the machine to the LOAD position.
2. Using a 5/32-in. hex wrench, loosen the cam
track mounting screw.
3. Adjust the cam track to Dimension A shown in
Figure 3 or as desired.
4. Tighten the cam track mounting screw.
4.2. Jaw
The jaw can be adjusted two steps to the right by
removing the four mounting screws and flipping the
clamp bracket over or upside down.
4.3. Cable Breakout Indicator
1. Loosen the cable breakout indicator locking
screw.
2. Lower the cable breakout indicator to shorten the
cable breakout dress. Raise the cable breakout
indicator to increase the cable breakout length.
3. Secure the cable breakout indicator locking
screw.
CAUTION
!
DO NOT OVERTIGHTEN. The locking screw is
threaded into aluminum. Overtightening will strip
the threads in the jaw.
5. MAINTENANCE
Lubricate the cam track with a good, quality, light
machine oil to ensure optimum service. Wipe off any
excess oil.
6. REPLACEMENT PARTS
Figure 5 lists the items that are recommended as
customer-replaceable parts. These items should be
inspected regularly. Customer-replaceable parts
should be stocked to prevent machine downtime in the
event that they require replacement.
Order replacement parts through your TE Connectivity
Representative, or call 1-800-526-5142, or send a
facsimile of your purchase order to 1-717-986-7605, or
write to:
CUSTOMER SERVICE (038-035)
TYCO ELECTRONICS CORPORATION
PO BOX 3608
HARRISBURG PA 17105-3608
PART NUMBER
230932-1
763596-1
980311-3
5-22284-6
761204-1
994916-1
DESCRIPTION
Bearing, Drawn Cup
Wire Holder
Air-Activated Cylinder
Compression Spring
Wire Clamp
Clamp Solenoid Valve
QTY PER ASSY
1
1
1
3
1
1
Figure 5
7. OTHER CABLE CLAMPS
Cable clamps not supplied with the specific
CHAMPOMATOR 2.5 bench terminating machine are
required to terminate other product lines on the
machine. For information on these cable clamps,
contact your representative.
8. REVISION SUMMARY
• New logo
Rev B
3 of 3