408-32199 Datasheet, PDF (3/3 Pages) TE Connectivity Ltd – CFP2 and CFP4 Cage Assembly Seating Tool

408-32199
7. Check the cage assembly for proper seating according to the following:
— widest section of each compliant pin is inside its intended pc board hole
— if present, the gap between the standoffs and the pc board is no more than 0.10 mm [.004 in.]
NOTE
For detailed application requirements for the cage assembly with heat sink, refer to the application specification 114-32146.
4. MAINTENANCE AND INSPECTION
1. Inspect the seating tool assembly immediately upon arrival to ensure that it has not been damaged
during shipment and that it conforms to the dimensions given in Figure 3.
2. Remove dust, moisture, and contaminants with a clean, soft brush or a lint -free cloth. Do not use
objects that could damage the components.
3. When the seating tool assembly is not in use, store it in a clean, dry area.
4. Periodically inspect the seating tool assembly for damage.
Seating Tool
Seating Tool Kit 1 4 Shown
Wall Support
A
D
F
E
B
C
SEATING TOOL CAGE ASSEMBLY
ASSEMBLY CONFIGURATION
2215078-1
2215078-2
2215080-1
2215080-4
2215080-5
CFP2 11
CFP2 12
CFP4 11
CFP4 14
CFP4 1x1
A
86.2 [3.39]
71.5 [2.82]
DIMENSION (mm [in.])
B
C
D
46.55 [1.83]
41.45 [1.63]
37.55 [1.48]
89.15 [3.51]
84.05 [3.31]
26.05 [1.03]
021.15 [.83]
038.2 [1.50]
92.65 [3.65]
87.75 [3.45]
26.05 [1.03] 40.0 [1.57] 21.15 [.83]
Figure 3
E
12.15 [.48]
09.25 [.36]
F
90.0 [3.74]
80.7 [3.18]
5. REVISION SUMMARY
 Added new part number and related information to tables in Figures 1 and 3
Rev B
3 of 3