408-32199 Datasheet, PDF (1/3 Pages) TE Connectivity Ltd – CFP2 and CFP4 Cage Assembly Seating Tool

CFP2 and CFP4 Cage Assembly Seating Tool
Assemblies 2215078-[ ] and 2215080-[ ]
(For Use with Heat Sink)
Instruction Sheet
408-32199
23 DEC 15 Rev B
Back of
Seating Tool
Seating Tool (14 Shown)
(Bottomed on Heat Sink)
Compliant Pin
Connector Not Shown
SEATING TOOL CAGE ASSEMBLY
ASSEMBLY CONFIGURATION
2215078-1
CFP2 11
2215078-2
CFP2 12
2215080-1
CFP4 11
2215080-4
CFP4 14
2215080-5
CFP4 1x1
Printed Circuit (PC)
Board (Ref)
PC Board
Support (Ref)
Figure 1
Heat Sink (14 Shown, Ref)
Cage Assembly
(14 Shown, Ref)
Wall Support (14 Shown)
(Shown Not Installed)
1. INTRODUCTION
The cage assembly seating tool assemblies listed in Figure 1 are used to seat the cage assemblies listed in
Figure 1 onto the pc board. The heat sink must be installed onto the cage assembly before seating. The cage
assembly contains compliant pins to allow solderless pc board installation. The seating tool assembly is not
designed to seat the connector.
NOTE
Dimensions in this instruction sheet are in metric units [with U.S. customary units in brackets]. Figures are not drawn to scale.
2. SETUP
1. A pc board support must be used to provide proper support for the pc board and to protect the pc
board and the cage assembly, heat sink, and connector from damage. Design the pc board support
using the following recommendations:
— at least 25.4 mm [1 in.] longer and wider than the pc board
— has flat surfaces with holes or a channel large enough and deep enough to receive any protruding
components of the cage assembly
2. Power for seating tool must be provided by an application tool (with a ram) capable of supplying a
downward force of 44.5 N [10 lb-force] per contact. For available application tools, call the number at
the bottom of this page.
CAUTION
Over-driving of the cage assembly will deform parts critical to the quality of the connection. Maximum force occurs prior to the
cage assembly bottoming on the pc board.
3. When setting up equipment to seat the cage assembly with heat sink, pay particular attention to the
following:
— seating tool assembly must be matched to cage assembly
— seating tool, cage assembly with heat sink, and application tool ram must be properly aligned
before cycling the application tool
© 2015 TE Connectivity family of companies
All Rights Reserved
*Trademark
PRODUCT INFORMATION 1-800- 5 2 2- 6 7 5 2
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.te.com.
TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product, and/or company names may be t rademarks of their respective owners.
1 of 3