408-6944 Datasheet, PDF (2/2 Pages) TE Connectivity Ltd – Uninsulated Bandolier Post Insertion Tool

408- 6944
Tool Aligned with
Adjacent Post
Receptacle End
NOTE
i
If inserting the post into a thick pc board, it may
be necessary to depress the handle several times
(repeating step 4) to ensure proper insertion.
5. Using Application Specification 114--25024,
inspect the inserted post for full and proper
insertion.
PC Board
or Panel
4. TOOL CERTIFICATION
This tool should be certified with the information
provided in Figure 4. TE Connectivity recommends
that you inspect the tool immediately upon arrival in
your factory and at regular scheduled intervals to
ensure that the tools have not been damaged during
handling.
.025
Square
Post
Wiring End
PC Board or
Panel Support
Figure 3
2. Push the wiring end of the post into the pc
board, making sure it is retained and aligned in the
board.
3. Fit the tip of the impact tool over the receptacle
end of the post, making sure the tip is oriented the
same as adjacent posts. See Figure 3.
4. Holding the tool and post perpendicular to the pc
board, use a straight steady motion and depress
the handle until the tool trips. Release the handle,
allowing the handle to retract. The post is fully
inserted when the tool tip bottoms on the pc board.
5. REPAIR/REPLACEMENT
A complete inventory should be stocked and
controlled to prevent lost time when replacement of
parts is necessary. Parts other than those listed in
Figure 4 should be replaced by TE to ensure quality
and reliability. Order additional tools or replacement
parts through your TE Representative, or call
1--800--526--5142, or send a facsimile of your
purchase order to 717--986--7605, or write to:
CUSTOMER SERVICE (038--035)
TYCO ELECTRONICS CORPORATION
PO BOX 3608
HARRISBURG PA 17105--3608
6. REVISION SUMMARY
: Updated document to corporate requirements
Jewel (Red)
1
2
15.88 [.625]
177.8 [7.00]
CUSTOMER REPLACEABLE PARTS FOR UNINSULATED BANDOLIER POST INSERTION TOOL 91419- 1
ITEM NO.
PART NUMBER
DESCRIPTION
QTY PER ASSEMBLY
TOOL WEIGHT
1
126007--2
INSERTION TOOL, Subassembly
2
527256--1
INSERTION TIP, Short Post
1
1
0.28 kg [10 oz.]
Figure 4
2 of 2
Rev B