108-19394 Datasheet, PDF (11/11 Pages) TE Connectivity Ltd – This specification covers the performance, test and quality requirements for the Tyco Electronics Keyed- IO 8 pairs IO board and cable connector

Product Specification
108-19394
4 QUALITY ASSURANCE PROVISIONS.
4.1 Qualification Testing.
Sample Selection.
Samples shall be prepared in accordance with applicable instructions and shall be selected random from
current production.
Unless details to perform test require otherwise, plugs shall be terminated on cables according to
applicable instructions and requirements specified in appropriate Application Specification and Instruction
Sheet.
Unless otherwise specified all test groups shall consist of a minimum of 5 connectors of applicable type.
Qualification inspection shall be verified by testing samples as specified in Para 3.5.
4.2 Requalification Testing.
If changes significantly affecting form, fit or function are made to product or manufacturing process,
product assurance shall coordinate re-qualification testing, consisting of all or part of original testing
sequence as determined by product, quality and reliability engineering.
4.3 Acceptance.
Acceptance is based on verification that product meets requirements of Para 3.4. Failures attributed to
equipment, test set-up, test sub-components or operator deficiencies shall not disqualify the product.
When product failure occurs, corrective action shall be taken and samples resubmitted for qualification.
Testing to confirm corrective action is required before re-submittal.
4.4 Quality Conformance Inspection.
Applicable Tyco Electronics quality inspection plan will specify sampling acceptable quality level to be
used. Dimensional and functional requirements shall be in accordance with applicable product drawing
and this specification.
Rev. A
R6-77 (Rev. 03-00)
Page 11 of 11