108-19394 Datasheet, PDF (1/11 Pages) TE Connectivity Ltd – This specification covers the performance, test and quality requirements for the Tyco Electronics Keyed- IO 8 pairs IO board and cable connector

Product
Specifications
108 – 19394
Rev.A 10/jul/2012
Keyed-IO Cable-Board Connector System
1 SCOPE .
1.1 Content.
This specification covers the performance, test and quality requirements for the Tyco Electronics Keyed-
IO 8 pairs IO board and cable connector. The cable-plug-assembly is used to connect the cable to the
board-connector.
1.2 Qualification.
When tests are performed on subject product, procedures specified in this Product Specification shall be
used. All inspections shall be performed using applicable inspection plan and product drawing.
1.3 Applicable partnumbers
The partnumbers of subject products:
• X-1551451-x
Keyed IO Cable Plug Assembly
• X-1551454-x
Keyed IO Connector Assembly, version 1 (referred to as BCv1)
• X-1551967-x
Keyed IO Connector Assembly, version 2 (referred to as BCv2)
1.4 Completion
Qualification of the Keyed IO Board Connector Assembly version 1 and version 2 have successfully been
completed and are reported in the following Qualification Test Reports;
• Keyed IO version 1: 501-19170
• Keyed IO version 2: 501-19179
This documentation is on file and available from Engineering Practices and Standards (EPS).
2 Applicable Documents.
The following documents form a part of this specification to extend specified herein. Unless otherwise
specified, latest edition of the document applies. In the event of conflict between the requirements in this
specification and the product drawing, product drawing shall take precedence. In the event of conflict
between requirements of this specification and referenced documents, this specification shall take
precedence.
2.1 Tyco Documents.
501-19170
Test report. Cable/Board Keyed-IO Connector assy (version 1)
501-19179
Test report. Cable/Board Keyed-IO Connector assy (version 2)
114-19132
Application specification Keyed-IO Cable/Board Connector System.
2.2 Other Documents.
IEC 60512
Basic testing procedures and measuring methods for electromechanical components
for electronic equipment.
J. Smits
DATE 10 JUL 2012
T de Boer
DATE 10 JUL 2012
Tyco Electronics Nederland B.V.
All international rights reserved
TE Connectivity
*Trademark
R6-76 (Rev. 03-00)
This information is confidential and propriety to TE
Connectivity and its worldwide subsidiaries and affiliates.
It may not be disclosed to anyone, other than TE
Connectivity personnel, without written authorization from
TE Connectivity Corporation, Harisburg, Pennsylvania USA
This specification is a controlled document and subject to
change. Contact the Engineering Control Organization for
the latest revision.
1 of 11
LOC H