408-4219 Datasheet, PDF (1/6 Pages) TE Connectivity Ltd – PRO-CRIMPER III Hand Crimping

PRO-CRIMPER* III Hand Crimping
Tool Assembly 318452-1 with
Die Assembly 318452-2
Instruction Sheet
408-4219
05 FEB 15 Rev C
PROPER USE GUIDELINES
Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. Hand tools are intended for occasional use and low
volume applications. A wide selection of powered application equipment for extended-use, production operations is available.
Die Assembly
318452-2
Stationary Jaw
Back of Tool
(Wire Side)
Moving Jaw
PRO-CRIMPER III
Hand Crimping Tool
Assembly Frame
354940-1 (408-9930)
Ratchet Adjustment
Wheel
The PRO-CRIMPER III Hand Crimping Tool is a “Commercial” grade tool
and is designed primarily for field installation, repair, maintenance work, or
prototyping in industrial, commercial, or institutional applications. Product
crimped with this tool will meet the crimp height requirement for hand tools
in the appropriate 114 series specification, but may not comply with other
feature parameters of the specification. TE Connectivity offers a variety of
tools to satisfy your performance requirements. For additional information,
contact the Tooling Assistance Center at 1-800-722-1111.
Stationary
Handle
Moving
Handle
1. INTRODUCTION
Figure 1
PRO-CRIMPER III Hand Crimping Tool Assembly 318452-1 consists of Die Assembly 318452-2 and
PRO-CRIMPER III Hand Crimping Tool Frame 354940-1. The hand tool assembly is used to crimp
COAXICON* 50-Ohm RF Series BNC Commercial Plug Connector 6-227079-8 onto Belden 89907
RG/U cable.
For connector assembly and cable stripping procedures, refer to Instruction Sheet 408-2798. For additional
information on the hand tool frame, refer to Instruction Sheet 408-9930.
Read these instructions thoroughly before using the hand tool assembly.
NOTE
Dimensions on this sheet are in millimeters [with inches in brackets]. Figures and illustrations are for reference only and are
not drawn to scale.
Reasons for reissue are provided in Section 9, REVISION SUMMARY.
2. DESCRIPTION (Figures 1 and 2)
The hand tool assembly features a tool frame with a stationary jaw and handle, a moving jaw, a moving handle,
and an adjustable ratchet that ensures full connector crimping.
The tool frame holds a die assembly with two crimping chambers. The die assembly features a wire anvil, an
insulation anvil, a wire indenter, and an insulation indenter. Die retaining pins and die retaining screws are used
to position and secure the dies in the tool frame.
Belden is a trademark.
© 2015 TE Connectivity family of companies
All Rights Reserved
*Trademark
TOOLING ASSISTANCE CENTER 1-800-722-1111
PRODUCT INFORMATION 1-800-522-6752
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.te.com.
TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product, and/or company names may be trademarks of their respective owners.
1 of 6