408-32145 Datasheet, PDF (1/5 Pages) TE Connectivity Ltd – Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools.

SDE HVA280 Die Assembly 2063013-[ ]
Instruction Sheet
408-32145
29 SEP 14 Rev A
PROPER USE GUIDELINES
Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. Hand tools are intended for occasional use and low
volume applications. A wide selection of powered application equipment for extended-use, production operations is available.
NOTE: SDE-SA Tool Frame
9-1478240-0 Can Also be
Used (408-8851)
Back of Tool
(Wire Side)
Die Assembly
2063013-[ ]
Moving Jaw
Stationary Jaw
Pivot Pin
PRO-CRIMPER III Hand
Crimping Tool Frame
354940-1 (408-9930)
Stationary Handle
Ratchet Adjustment Wheel
The PRO-CRIMPER III Hand Crimping Tool is a •Commercial" grade
tool and is designed primarily for field installation, repair, maintenance
work, or prototyping in industrial, commercial, or institutional applications.
Product crimped with this tool will meet the crimp height requirement for
hand tools in the appropriate 114 series specification, but may not comply
with other feature parameters of the specification. TE Connectivity offers a
variety of tools to satisfy your performance requirements. For additional
information, contact the Tooling Assistance Center at 1-800-722-1111.
Moving Handle
DIE PART NUMBER
2063013-1
2063013-2
2063013-3
2063013-4
2063013-5
2063013-6
NEST SIZE “A” (mm)
9.80
9.40
6.80
6.20
10.75
7.40
Figure 1
CONNECTOR NAME
HVA280 MULTI-CORE
HVA280
HVA280-2phi
HVA280-2phi
HVA280 MULTI-CORE
HVA280-2phi
1. INTRODUCTION
The SDE die assembly 2063013-[ ] is used to crimp various HVA280 connectors. Refer to Figure 1 for specific
connector types.
NOTE
Dimensions on this sheet are in millimeters. Figures and illustrations are for identification only and are not drawn to scale.
For additional information on the hand tool frame, refer to Instruction Sheet 408-9930. For the selection of
Series F coaxial connectors, contact TE Connectivity Product Engineering for connector recommendations at
the number at the bottom of this page.
Reasons for reissue of this instruction sheet are provided in Section 8, REVISION SUMMARY.
2. DESCRIPTION
The tool features a tool frame with a stationary jaw and handle, a moving jaw, a moving handle, and an
adjustable ratchet that ensures full connector crimping. The tool frame holds the die assembly.
The die assembly features an anvil and a nest containing a hex crimping cavity. Each die is held in the hand
tool by a single screw.
© 2014 TE Connectivity family of companies
All Rights Reserved
*Trademark
TOOLING ASSISTANCE CENTER 1-800-722-1111
PRODUCT INFORMATION 1-800-522-6752
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.te.com.
TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product, and/or company names may be trademarks of their respective owners.
1 of 5