CM04RC01T Datasheet, PDF (7/10 Pages) Taiyo Yuden (U.S.A.), Inc – COMMON MODE CHOKE COILS (FOR DC AND SIGNAL LINES) SMD TYPE

RELIABILITY DATAɹ
2/4
Specifled Value
Item
Surface Mount
High current
inductors 08 Type
Surface Mount High
current inductors
04/05/06 Type
CommonMode
Choke Coils
CM04RC
CommonMode
Choke Coils
BU05MC
Balun Transformers
BU05MC
Test Method and Remarks
10.Standard donndityonn
Note on standard condition: "standard condition"
referred to herein is defined as follows:
5 to 35C of temperature, 45 to 85% relative humidity and 86 to 106kPa of air pressure.
When there are questions conceming measurement results:
In order to provide correlation data, the test shall be conducted under condition of 20M2C of tempera-
ture, 45 to 85% relative humidity and 86 to 106kPa of air pressure.
Unless otherwise specified, all the tests are conducted under the "standard condition."
5
11.Insulation resistanceD
between wires
100ME min.
12.Insulation resistanceD
between wire and core
13.Rated current
14.Withstanding voltageD
between wires
100ME min.
15.Withstanding voltageD
between wire and core
No abnormality
16.Adhesion of terminal elec- No abnormality
trode
Within the specification
No abnormality
17.Resisitance to vibration Impedance changeDWithinDM5L
Refer to individual specification.
18.Solderability
95L or more of mounting terminal side At least 75L of terminal electrode is
shall be covered with tresh solder.
covered by new solder.
SMD inductorD
Applied voltageD100VDC DurationD60sec.
Commom mode choke coilD
Applied voltageDRated voltage
DurationD60 sec.
SMD inductorD
Applied voltageD100VDC DurationD60sec.
Commom mode choke coilD
Applied voltageDRegulation voltage
DurationD60 sec.
SMD inductorD
Applied voltageD500VAC
DurationD60 sec.
SMD inductorD
Set testing jigs perpendicularly to top surface of specimen mounted
on printed board, and apply specified static load for 5 sec.
Specified static load
Type
static load
N08DP
10N
NP04S
N06D
5N
NP06D
SMD inductor, Commom mode choke coilD
Accoding to JIS C0040
DirectionsD2 hrs each in X, Y, and Z directions. TotalD6 hrs
Frequency rangeD10 to 55 to 10 Hz f1 min.g
AmplitudeD1.5mm fShall not exceed acceleration 196m/s²g
Mounting methodDsoldering onto printed board
RecoveryDAt least 2 hrs of recovery under the standard
condition after the test,followed by the mea-
surement within 24 hrs.
A kind of vibrationDA
SMD inductor
Solder temperatureD230M5C
DurationD2M0.5 sec.
Immersion depthDAll sides of mounting terminal shall
be immersed.
Commom mode choke coilD
CM04RCYBU05MC
Solder temperature
235M5C
Duration
2M0.5 sec.
Immersion depth Up to 0.5mm from terminal root
393